How To Fix ECATT_TDW050 - &1 &2 does not exist

SAP Error Message - Details

• Message type: E = Error

• Message class: ECATT_TDW - Message Class for Test Data Wizard

• Message number: 050

• Message text: &1 &2 does not exist

What causes this issue?

The above-mentioned text was not found in the system because:
- The text object does not exist
- The system is set to the wrong text object

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

System Response

How to fix this error?

Use SE61 to create a text with the above-mentioned name.
Check the entries in table ECCUSTOM.

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message ECATT_TDW050 - &1 &2 does not exist ?

  The SAP error message ECATT_TDW050 typically indicates that a specific test data or test data container does not exist in the system. This error is often encountered when using the eCATT (extended Computer Aided Test Tool) for automated testing in SAP.
  Cause:
  
  Non-Existent Test Data: The test data or test data container referenced in the eCATT script does not exist in the system.
  Incorrect Naming: There may be a typo or incorrect naming in the test data container or test data reference.
  Transport Issues: If the test data was transported from another system, it may not have been included or may not exist in the target system.
  Authorization Issues: The user executing the eCATT may not have the necessary authorizations to access the specified test data.
  
  Solution:
  
  Verify Test Data Existence: Check if the test data or test data container exists in the system. You can do this by navigating to the eCATT transaction (e.g., SECATT) and looking for the specified test data.
  Correct Naming: Ensure that the names used in the eCATT script match exactly with the names of the test data containers. Pay attention to case sensitivity and any special characters.
  Create Test Data: If the test data does not exist, you may need to create it. This can be done through the eCATT interface or by importing data if available.
  Check Transport Requests: If the test data was supposed to be transported, check the transport requests to ensure that the test data was included and successfully imported into the target system.
  Review Authorizations: Ensure that the user executing the eCATT has the necessary authorizations to access the test data. You may need to consult with your SAP security team to verify this.
  
  Related Information:
  
  eCATT Documentation: Refer to the official SAP documentation for eCATT for detailed information on how to create and manage test data.
  SAP Notes: Check for any relevant SAP Notes that may address specific issues related to eCATT and test data management.
  Community Forums: SAP Community and other forums can be helpful for finding similar issues faced by other users and their solutions.
  
  If the problem persists after following these steps, consider reaching out to your SAP support team for further assistance.