How To Fix DT660 - Latest values (&1/&2) were applied; active values were (&3/&4)

DT660 - Overview

• Message type: E = Error

• Message class: DT - Table activation (incl. indexes)

• Message number: 660

• Message text: Latest values (&1/&2) were applied; active values were (&3/&4)

What causes this issue?

The buffering mode and, for generic buffering, the number of key fields
in the generic key is specified for the latest and active version.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message DT660 - Latest values (&1/&2) were applied; active values were (&3/&4) ?

  The SAP error message DT660 typically indicates a discrepancy between the latest values and the active values in a data transport or configuration context. This message is often encountered in scenarios involving data transfer, configuration management, or system settings where the system is trying to reconcile different sets of values.
  
  Cause:
  The error message DT660 arises when:
  
  The latest values (e.g., from a transport request or a configuration change) do not match the currently active values in the system.
  There may have been changes made to the configuration or data that have not been properly transported or activated.
  The system is trying to apply new settings or data that conflict with existing active settings.
  
  
  Solution:
  To resolve the DT660 error, you can follow these steps:
  
  
  Check Transport Requests: Ensure that all relevant transport requests have been properly imported into the system. If there are pending transports, complete them.
  
  
  Review Configuration Changes: If you have made manual changes to the