How To Fix DRF_CHECK_CUSTOMIZIN025 - Service operation &1 assigned to outb.impl. &2 is an inbound serv.oper.

SAP Error Message - Details

• Message type: E = Error

• Message class: DRF_CHECK_CUSTOMIZIN - DRF - Check Customizing Report Messages

• Message number: 025

• Message text: Service operation &1 assigned to outb.impl. &2 is an inbound serv.oper.

What causes this issue?

You can only assign service operations of operation type 'Outbound' to
outbound implementations.

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

System Response

How to fix this error?

Assign an outbound service operation to outbound implementation &V2&.

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message DRF_CHECK_CUSTOMIZIN025 - Service operation &1 assigned to outb.impl. &2 is an inbound serv.oper. ?

  The SAP error message DRF_CHECK_CUSTOMIZIN025 indicates that there is a configuration issue related to the assignment of service operations in the Data Replication Framework (DRF). Specifically, it suggests that a service operation intended for outbound implementation is incorrectly assigned to an inbound service operation.
  Cause:
  This error typically arises when:
  
  The service operation defined in the system is not correctly configured for the intended direction (inbound vs. outbound).
  There may be a mismatch between the service operation and the implementation assigned to it.
  The configuration settings in the DRF are not aligned with the expected behavior of the service operations.
  
  Solution:
  To resolve this error, you can follow these steps:
  
  
  Check Service Operation Configuration:
  
  Go to the transaction code DRFOUT (for outbound service operations) or DRFIN (for inbound service operations).
  Verify the configuration of the service operation mentioned in the error message. Ensure that it is correctly set up for the intended direction (outbound or inbound).
  
  
  
  Review Implementation Assignments:
  
  Check the assignment of the service operation to the implementation. Ensure that the outbound implementation is assigned to an outbound service operation and not to an inbound one.
  If necessary, reassign the service operation to the correct implementation.
  
  
  
  Adjust Customizing Settings:
  
  Navigate to the customizing settings for the Data Replication Framework. Ensure that the settings for service operations are correctly defined.
  You can access the customizing settings via transaction code SPRO and then navigate to the relevant sections for DRF.
  
  
  
  Test the Configuration:
  
  After making the necessary adjustments, test the configuration to ensure that the error no longer occurs. You can do this by triggering the replication process again.
  
  
  
  Consult Documentation:
  
  If the issue persists, refer to the SAP documentation or help portal for additional guidance on configuring service operations in the Data Replication Framework.
  
  
  
  Related Information:
  
  
  Transaction Codes:
  
  DRFOUT: Outbound service operations configuration.
  DRFIN: Inbound service operations configuration.
  SPRO: Access to customizing settings.
  
  
  
  SAP Notes and Documentation:
  
  Check for any relevant SAP Notes that may address known issues or provide additional guidance on configuring DRF.
  Review the official SAP Help documentation for the Data Replication Framework for best practices and configuration guidelines.
  
  
  
  By following these steps, you should be able to identify and resolve the cause of the DRF_CHECK_CUSTOMIZIN025 error in your SAP system.