How To Fix DMEE_ABA707 - Node &1: Avoid using exit module and conversion function simultaneously.

DMEE_ABA707 - Overview

• Message type: E = Error

• Message class: DMEE_ABA - Messages for Data Medium Exchange Engine

• Message number: 707

• Message text: Node &1: Avoid using exit module and conversion function simultaneously.

What causes this issue?

You have defined an exit module and conversion function for a node at
the same time.
The exit module for a DMEE node has two purposes:
1.) Assigning a value to the DMEE node
2.) Performing a custom conversion on the node's value
Therefore, if you have already selected the Exit module as mapping
procedure with a conversion function for the DMEE node, the conversion
may be doesn't provide the result as you expected.

How to fix this error?

In order to resolve the conflict you should implement the desired
conversion functionality within your own defined exit module.
Alternatively you can leave the selected standard conversion function at
your own risk.

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message DMEE_ABA707 - Node &1: Avoid using exit module and conversion function simultaneously. ?

  The SAP error message DMEE_ABA707 indicates that there is a conflict in the configuration of the Data Medium Exchange Engine (DMEE) where both an exit module and a conversion function are being used simultaneously in the same node. This is not allowed because it can lead to ambiguity in processing the data.
  
  Cause:
  The error occurs when:
  
  A node in the DMEE tree is configured to use both an exit module (a custom ABAP function that is called during processing) and a conversion function (a predefined function that transforms data) at the same time.
  This configuration is not supported because the DMEE engine cannot determine which processing method to apply.
  
  
  Solution:
  To resolve this error, you need to modify the configuration of the DMEE tree as follows:
  
  Identify the Node: Locate the node mentioned in the error message (indicated by &1).
  Check Configuration: Open the DMEE tree and check the properties of the specified node.
  Remove Conflict:
  If an exit