How To Fix DMEE_ABA358 - Node &1: function module &2 has incorrect interface

DMEE_ABA358 - Overview

• Message type: E = Error

• Message class: DMEE_ABA - Messages for Data Medium Exchange Engine

• Message number: 358

• Message text: Node &1: function module &2 has incorrect interface

What causes this issue?

You have assigned the exit module &V2& to node &V1&. However, the
interface for this function module is not one of the predefined
interfaces.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Make sure that your exit module uses the interface of one of the
following module templates:
<DS:FU.DMEE_EXIT_TEMPLATE_ABA>DMEE_EXIT_TEMPLATE_ABA</>
<DS:FU.DMEE_EXIT_TEMPLATE_EXTEND_ABA>DMEE_EXIT_TEMPLATE_EXTEND_ABA</>

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message DMEE_ABA358 - Node &1: function module &2 has incorrect interface ?

  The SAP error message DMEE_ABA358 indicates that there is an issue with the function module specified in the DMEE (Data Medium Exchange Engine) configuration. Specifically, it suggests that the function module has an incorrect interface, which means that the parameters expected by the function module do not match the parameters defined in the DMEE configuration.
  
  Cause:
  
  Incorrect Function Module: The function module specified in the DMEE node may not exist or may not be the correct one for the intended purpose.
  Parameter Mismatch: The parameters defined in the DMEE configuration for the function module do not match the actual parameters of the function module. This could be due to changes in the function module or incorrect configuration.
  Version Issues: If the function module has been updated or changed in a newer version of SAP, the DMEE configuration may not have been updated accordingly.
  
  
  Solution:
  
  Check Function Module: Verify that the function module specified in the DMEE