How To Fix DMEE384 - Error in checks for node &1: constant &2 has incorrect format

SAP Error Message - Details

• Message type: E = Error

• Message class: DMEE - Messages for Data Medium Exchange Engine

• Message number: 384

• Message text: Error in checks for node &1: constant &2 has incorrect format

What causes this issue?

If a comparison value is a constant, but it does not refer to a numeric
value, then you must enter it enclosed in single quotation marks, for
example 'EURO'.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message DMEE384 - Error in checks for node &1: constant &2 has incorrect format ?

  The SAP error message DMEE384 indicates that there is an issue with the format of a constant value in the Data Medium Exchange (DMEE) configuration. This error typically arises when the format of a constant defined in the DMEE tree does not match the expected format for that particular node.
  Cause:
  
  Incorrect Format: The constant defined in the DMEE tree does not conform to the expected data type or format. For example, if a constant is expected to be numeric but is defined as a string, or if the length of the constant exceeds the allowed limit.
  Configuration Issues: There may be a misconfiguration in the DMEE tree structure or the constants defined within it.
  Data Type Mismatch: The constant may not match the data type expected by the node where it is being used.
  
  Solution:
  
  
  Check the DMEE Configuration:
  
  Go to the DMEE tree where the error is occurring.
  Identify the node mentioned in the error message (node &1).
  Review the constant (constant &2) that is causing the issue.
  
  
  
  Verify Constant Format:
  
  Ensure that the constant is defined with the correct data type (e.g., numeric, alphanumeric).
  Check the length of the constant to ensure it does not exceed the maximum allowed length for that node.
  
  
  
  Adjust the Constant:
  
  If the constant is incorrectly formatted, modify it to match the expected format.
  If necessary, create a new constant with the correct format and replace the incorrect one in the DMEE tree.
  
  
  
  Test the Configuration:
  
  After making changes, test the DMEE configuration to ensure that the error is resolved.
  Generate the data medium file again to confirm that the issue has been fixed.
  
  
  
  Related Information:
  
  Transaction Codes: You can use transaction codes like DMEE to access the DMEE configuration.
  Documentation: Refer to SAP documentation for detailed information on DMEE configuration and the expected formats for constants.
  SAP Notes: Check for any relevant SAP Notes that may provide additional insights or solutions related to this error message.
  
  If the issue persists after following these steps, consider reaching out to your SAP support team or consulting the SAP Community for further assistance.