How To Fix DMEE333 - Node &1: level increases by &3

SAP Error Message - Details

• Message type: E = Error

• Message class: DMEE - Messages for Data Medium Exchange Engine

• Message number: 333

• Message text: Node &1: level increases by &3

What causes this issue?

Node &V1& has the level &V2&, which means that its level is higher than
that of the node directly above it in the tree by a factor of &V3&.
This is not permitted since the level cannot increase by more than a
factor of one from node to node.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message DMEE333 - Node &1: level increases by &3 ?

  The SAP error message DMEE333 typically occurs in the context of the Data Medium Exchange Engine (DMEE) when there is an issue with the structure of the DMEE tree. This error indicates that the level of a node in the DMEE tree is increasing unexpectedly, which can lead to inconsistencies in the data structure.
  Cause:
  The error message DMEE333: "Node &1: level increases by &3" suggests that the node specified by &1 is trying to increase its level by &3, which is not allowed. In DMEE, each node has a defined level, and the levels must follow a specific hierarchy. If a node is defined to be at a certain level, and then a child node is defined at a higher level than its parent, this will trigger the error.
  Solution:
  To resolve this error, you can follow these steps:
  
  
  Check the DMEE Tree Structure:
  
  Open the DMEE tree in transaction code DMEE.
  Review the hierarchy of nodes to ensure that the levels are correctly defined. Each child node should have a level that is one greater than its parent node.
  
  
  
  Adjust Node Levels:
  
  If you find that a node is incorrectly set to a higher level than its parent, adjust the level of the node to ensure it follows the correct hierarchy.
  Make sure that the levels of all nodes are consistent and follow the expected structure.
  
  
  
  Validate the DMEE Configuration:
  
  After making changes, validate the DMEE configuration to ensure that there are no other structural issues.
  You can use the "Check" function in the DMEE transaction to identify any other potential issues.
  
  
  
  Test the Output:
  
  Once the adjustments are made, generate the output again to see if the error persists.
  
  
  
  Related Information:
  
  Transaction Codes: Use transaction DMEE to access the Data Medium Exchange Engine configuration.
  Documentation: Refer to SAP Help documentation for DMEE for detailed information on node structure and configuration.
  SAP Notes: Check for any relevant SAP Notes that might address specific issues related to DMEE333 or provide additional guidance.
  
  If the problem persists after following these steps, consider reaching out to your SAP support team or consulting with an SAP expert who specializes in DMEE configurations.