How To Fix DG535 - No ISO code found for unit &1

SAP Error Message - Details

• Message type: E = Error

• Message class: DG - DG: Messages for Dangerous Goods Management

• Message number: 535

• Message text: No ISO code found for unit &1

What causes this issue?

A value for the material &V2& has been entered in the field &V3& . The
system cannot find an ISO code for the associated unit&V1& .

System Response

The system uses the SAP unit instead of the ISO code. If the target
system is an SAP system, the IDoc is posted correctly.

How to fix this error?

INCLUDE EHS_NA_ADMIN OBJECT DOKU ID TX

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Procedure for System Administrators

In the Customizing activity <DS:SIMG.SIMG_CFMENUOLMSOMSC>Check Units of
Measurement</>, enter the ISO code for unit &V1&.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message DG535 - No ISO code found for unit &1 ?

  The SAP error message DG535 "No ISO code found for unit &1" typically occurs when the system is unable to find the ISO code associated with a specific unit of measure (UoM) in the system. This can happen in various contexts, such as during the creation of materials, when processing transactions, or when generating reports that involve units of measure.
  Cause:
  
  Missing ISO Code: The primary cause of this error is that the unit of measure (UoM) specified does not have an associated ISO code in the system.
  Incorrect Configuration: The unit of measure may not be properly configured in the system, or it may not be defined in the relevant tables.
  Data Inconsistency: There may be inconsistencies in the data, such as missing entries in the unit of measure master data.
  
  Solution:
  
  
  Check Unit of Measure Configuration:
  
  Go to the transaction code CUNI (Unit of Measure Conversion) or OMN1 (Maintain Units of Measure) in SAP.
  Verify if the unit of measure in question is defined and check if it has an associated ISO code.
  
  
  
  Define ISO Code:
  
  If the ISO code is missing, you can define it by editing the unit of measure settings. Ensure that the UoM is correctly linked to the appropriate ISO code.
  
  
  
  Use Standard Units:
  
  If possible, use standard units of measure that are already defined in the system with ISO codes to avoid this error.
  
  
  
  Check Custom Developments:
  
  If there are any custom developments or enhancements in your SAP system that involve units of measure, ensure that they are correctly handling the UoM and ISO code mappings.
  
  
  
  Consult Documentation:
  
  Review SAP documentation or help resources for any specific guidelines related to the units of measure and ISO codes.
  
  
  
  Contact SAP Support:
  
  If the issue persists after checking the above points, consider reaching out to SAP support for further assistance.
  
  
  
  Related Information:
  
  Unit of Measure Tables: The relevant tables for units of measure in SAP include:
  
  T006: Units of Measure
  T006A: Units of Measure (Language-dependent)
  
  
  ISO Codes: ISO codes are standardized codes that represent units of measure, and they are important for international trade and compliance.
  Transaction Codes: Familiarize yourself with transaction codes related to unit of measure management, such as CUNI, OMN1, and MM02 (Change Material).
  
  By following these steps, you should be able to resolve the DG535 error and ensure that your units of measure are correctly configured in the SAP system.