How To Fix CY110 - There is no setup and no teardown at work center &

CY110 - Overview

• Message type: E = Error

• Message class: CY - Capacity Requirements Planning

• Message number: 110

• Message text: There is no setup and no teardown at work center &

What causes this issue?

You are trying to reduce the setup time. However you cannot do this
because in work center &V1& either

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

there is no formula was entered for calculating the setup and teardown
times or
the standard values that were defined in the work center &V1& are not
entered in the formulas for calculating the setup/teardown time.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message CY110 - There is no setup and no teardown at work center & ?

  The SAP error message CY110 indicates that there is no setup and no teardown defined for a specific work center in the system. This error typically arises during the planning or scheduling of production orders when the system expects to find setup and teardown times associated with the work center but does not.
  
  Cause:
  
  Missing Setup/Teardown Data: The work center in question does not have any setup or teardown times defined in its configuration.
  Incorrect Work Center Assignment: The production order may be assigned to a work center that is not properly configured.
  Master Data Issues: There may be issues with the master data related to the work center or the routing.
  
  
  Solution:
  To resolve the CY110 error, you can take the following steps:
  
  
  Check Work Center Configuration:
  
  Go to the transaction code CR02 (Change Work Center) or CR01 (Create Work Center).
  Enter the work center ID and check the "Setup" and "Teardown" times in the "Capacity" tab.
  If they