How To Fix CUMTX271 - Multiple values entered for single-value characteristic & in line &

SAP Error Message - Details

• Message type: E = Error

• Message class: CUMTX - Variant Configuration - Master Data Maintenance

• Message number: 271

• Message text: Multiple values entered for single-value characteristic & in line &

What causes this issue?

You want to display the table as a decision table. You can only do this
if the table lines show one value only in the columns for single
characteristics.

System Response

The system found that the column for characteristic &V1& in table line
&V2& contains several values, although the characteristic is
single-value.

How to fix this error?

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message CUMTX271 - Multiple values entered for single-value characteristic & in line & ?

  The SAP error message CUMTX271 indicates that multiple values have been entered for a single-value characteristic in a specific line item. This typically occurs in the context of configuration or master data management, where certain characteristics are defined to accept only a single value, but the user has attempted to input more than one.
  Cause:
  
  Incorrect Data Entry: The user may have mistakenly entered multiple values for a characteristic that is defined to accept only one.
  Configuration Issues: The characteristic may be incorrectly configured in the system, allowing for multiple entries when it should not.
  Data Migration Issues: If data was migrated from another system, it may have been incorrectly formatted, leading to multiple values being present where only one is allowed.
  
  Solution:
  
  Review Input: Check the line item mentioned in the error message and ensure that only a single value is entered for the characteristic in question.
  Correct Configuration: If the characteristic is supposed to allow multiple values, consider changing its configuration in the system. This may involve adjusting the settings in the characteristic definition.
  Data Cleanup: If the error is due to data migration, perform a data cleanup to ensure that all entries conform to the expected format.
  Consult Documentation: Refer to SAP documentation or help resources for guidance on how to handle single-value characteristics and ensure compliance with the system's requirements.
  
  Related Information:
  
  Transaction Codes: You may need to use transaction codes like CT04 (for characteristics) or CU50 (for configuration) to review and modify the characteristics.
  SAP Notes: Check for any relevant SAP Notes that may address this specific error or provide additional troubleshooting steps.
  User Training: Ensure that users are trained on the correct data entry procedures to prevent similar errors in the future.
  
  If the issue persists after following these steps, it may be beneficial to consult with your SAP support team or a technical consultant for further assistance.