How To Fix CPOC130 - You may use characteristic &1 in input validations/signatures only

SAP Error Message - Details

• Message type: E = Error

• Message class: CPOC - PP-PI-PMA: Process Operator Cockpit Messages

• Message number: 130

• Message text: You may use characteristic &1 in input validations/signatures only

What causes this issue?

You may use the following characteristics to define input validations
and the execution of signatures only:
PPPI_SIGNATURE_AUTHORIZATION
PPPI_SIGNATURE_STRATEGY
PPPI_SIGNATURE_MODE
You have, however, used one of these characteristics in the process
instruction although you have <LS>neither</> defined an input
validation <LS>nor</> the execution of a signature.
The system does not process this characteristic.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Delete the characteristic in the process instruction.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message CPOC130 - You may use characteristic &1 in input validations/signatures only ?

  The SAP error message CPOC130 indicates that a specific characteristic (denoted by &1) is being used in a context where it is not allowed. This error typically arises in the context of SAP's configuration for Product Lifecycle Management (PLM) or Advanced Planning and Optimization (APO) when dealing with characteristics and their usage in various contexts.
  
  Cause:
  The error occurs when:
  
  A characteristic is being used in a context that is not permitted, such as in output validations or in contexts where only input validations or signatures are allowed.
  The characteristic may be defined in a way that restricts its use to certain scenarios, such as only being applicable for input validation or signature checks.
  
  
  Solution:
  To resolve the CPOC130 error, you can take the following steps:
  
  
  Check Characteristic Configuration:
  
  Go to the configuration of the characteristic in question. Ensure that it is set up correctly for the intended use.
  Verify if the characteristic is defined for input validation or