How To Fix CPE_IPC543 - Invalid CPE source routine &4

SAP Error Message - Details

• Message type: E = Error

• Message class: CPE_IPC - CPE: Message Class for Pricing Engine Part

• Message number: 543

• Message text: Invalid CPE source routine &4

What causes this issue?

An error occurred with the commodity pricing engine (CPE) during FA
procedure determination, formula assembly, formula evaluation, or
formula analysis.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Contact your system administrator.

Procedure for System Administrators

The error occurred with the following object:
Pricing Condition Type, Term Number: &V1&
Source Type: &V2&
Period Determination Rule: &V3&

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message CPE_IPC543 - Invalid CPE source routine &4 ?

  The SAP error message CPE_IPC543 "Invalid CPE source routine &4" typically occurs in the context of the SAP Convergent Charging (SAP CC) application. This error indicates that there is an issue with the configuration of the charging process, specifically related to the source routine that is being referenced.
  Cause:
  
  Invalid Source Routine: The source routine specified in the charging configuration does not exist or is not correctly defined in the system.
  Configuration Issues: There may be a misconfiguration in the charging logic or the charging model that references the source routine.
  Transport Issues: If the configuration was transported from another system, the source routine may not have been included or may not exist in the target system.
  Version Mismatch: The source routine may be incompatible with the current version of the SAP CC system.
  
  Solution:
  
  Check Source Routine: Verify that the source routine referenced in the error message exists in the system. You can do this by navigating to the relevant configuration area in SAP CC.
  Review Configuration: Ensure that the charging model and any related configurations are set up correctly. Look for any typos or incorrect references.
  Transport Validation: If the configuration was transported, check the transport logs to ensure that all necessary objects were included and that there were no errors during the transport process.
  Update or Correct: If the source routine is missing or incorrect, you may need to create or update it in the system. This may involve coding or adjusting the logic in the source routine.
  Consult Documentation: Refer to the SAP documentation for Convergent Charging for guidance on how to properly configure source routines and charging models.
  Contact SAP Support: If the issue persists after checking the above points, consider reaching out to SAP Support for further assistance.
  
  Related Information:
  
  SAP Notes: Check for any relevant SAP Notes that may address this specific error or provide additional troubleshooting steps.
  SAP Community: Engage with the SAP Community forums to see if other users have encountered and resolved similar issues.
  Documentation: Review the SAP Convergent Charging documentation for best practices on configuring source routines and charging models.
  
  By following these steps, you should be able to identify and resolve the cause of the CPE_IPC543 error in your SAP environment.