How To Fix CONNECT_PRC_SAPCND023 - Only the characteristics' ' and 'A' are supported for the access category

CONNECT_PRC_SAPCND023 - Overview

• Message type: E = Error

• Message class: CONNECT_PRC_SAPCND -

• Message number: 023

• Message text: Only the characteristics' ' and 'A' are supported for the access category

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

CONNECT_PRC_SAPCND023 - Details

• The SAP error message CONNECT_PRC_SAPCND023 indicates that there is an issue with the characteristics being used in a condition record or access sequence. Specifically, it states that only the characteristics ' ' (blank) and 'A' are supported for the access category in question.
  
  Cause:
  This error typically arises when:
  
  You are trying to use characteristics in a condition record that are not supported for the specified access category.
  The access sequence is configured to only allow certain characteristics, and the ones you are trying to use do not match those allowed characteristics.
  There may be a configuration issue in the condition type or access sequence setup.
  
  
  Solution:
  To resolve this error, you can take the following steps:
  
  
  Check Access Sequence Configuration:
  
  Go to the configuration of the access sequence associated with the condition type you are using.
  Verify which characteristics are defined for that access sequence. Ensure that you are only using the allowed characteristics (in this case, only '