How To Fix CONNECT_PRC_SAPCND007 - Unit of measure &1 (for product) unknown.

SAP Error Message - Details

• Message type: E = Error

• Message class: CONNECT_PRC_SAPCND -

• Message number: 007

• Message text: Unit of measure &1 (for product) unknown.

What causes this issue?

Unit of measure &v1& for data element &v2& is not yet defined in
product master.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Leave unit of measure empty and copy proposal or use F4 help. If no
unit of measure has been accepted without errors, no unit of measure is
maintained in the product master or there is none in the buffer.
Save the transaction and save the automatic proposal.

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message CONNECT_PRC_SAPCND007 - Unit of measure &1 (for product) unknown. ?

  The SAP error message CONNECT_PRC_SAPCND007 indicates that there is an issue with the unit of measure (UoM) for a specific product in the system. This error typically arises when the system cannot find the specified unit of measure for the product in question, which can lead to issues in processing transactions or data related to that product.
  Cause:
  
  Missing Unit of Measure: The specified unit of measure for the product is not defined in the system.
  Incorrect Configuration: The product may be configured incorrectly, leading to a mismatch between the expected and actual units of measure.
  Data Inconsistency: There may be inconsistencies in the master data, such as the material master or product master, where the unit of measure is not properly maintained.
  Transport Issues: If the product or its unit of measure was recently transported from another system, it may not have been set up correctly in the target system.
  
  Solution:
  
  Check Material Master: Go to the material master (transaction code MM03) and verify that the unit of measure is correctly defined for the product. Ensure that the UoM is active and properly maintained.
  Maintain Unit of Measure: If the unit of measure is missing, you can add it using transaction code MM02 to modify the material master and include the necessary UoM.
  Review Configuration: Check the configuration settings in the relevant modules (like MM, SD, or PP) to ensure that the unit of measure settings are correct.
  Data Consistency Check: Run data consistency checks to identify any discrepancies in the master data that may be causing the issue.
  Transport Request: If the issue arose after a transport, ensure that all necessary objects related to the product and its unit of measure were included in the transport request.
  
  Related Information:
  
  Unit of Measure Tables: The relevant tables for units of measure in SAP include:
  
  T006 (Units of Measure)
  T006A (Units of Measure: Language-dependent Texts)
  
  
  Transaction Codes:
  
  MM03: Display Material
  MM02: Change Material
  MM01: Create Material
  
  
  SAP Notes: Check for any SAP Notes related to this error message for additional guidance or patches that may address the issue.
  
  If the problem persists after following these steps, it may be beneficial to consult with your SAP support team or refer to SAP documentation for further troubleshooting.