How To Fix COM_PME_PARSER578 - Conflict of values: Attribute &1 with value &2

SAP Error Message - Details

• Message type: E = Error

• Message class: COM_PME_PARSER - Configuration

• Message number: 578

• Message text: Conflict of values: Attribute &1 with value &2

What causes this issue?

The value &v2& was entered in configuration for the attribute &v1&
. This value contradicts another, already existing attribute value.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message COM_PME_PARSER578 - Conflict of values: Attribute &1 with value &2 ?

  The SAP error message COM_PME_PARSER578 indicates a conflict of values for a specific attribute in the context of Product Master Data or similar areas where attributes are defined. The message typically appears when there is an inconsistency or conflict in the values assigned to a particular attribute for a product or material.
  Cause:
  The error is usually caused by one of the following reasons:
  
  Inconsistent Data: The attribute value being assigned conflicts with existing values or rules defined in the system.
  Validation Rules: There may be validation rules in place that prevent certain combinations of attribute values from being valid.
  Data Entry Errors: Manual data entry errors can lead to conflicts if the same attribute is assigned different values in different contexts.
  Configuration Issues: The configuration of the product master data or the specific attributes may not allow for the combination of values being used.
  
  Solution:
  To resolve the error, you can take the following steps:
  
  Check Attribute Values: Review the attribute &1 and its assigned value &2. Ensure that the value is valid and does not conflict with existing data.
  Review Validation Rules: Check if there are any validation rules or dependencies that might be causing the conflict. This can often be found in the configuration settings for the product master data.
  Correct Data Entry: If the error is due to a data entry mistake, correct the value being assigned to the attribute.
  Consult Documentation: Refer to SAP documentation or help resources for specific guidelines on the attribute in question.
  Use Transaction Codes: Utilize relevant transaction codes (like MM01 for material creation or MM02 for material change) to review and modify the product master data.
  Seek Help from SAP Support: If the issue persists and you cannot identify the cause, consider reaching out to SAP support for assistance.
  
  Related Information:
  
  Transaction Codes: Familiarize yourself with transaction codes related to product master data management, such as MM01, MM02, and MM03.
  SAP Notes: Check for any SAP Notes related to this error message for additional insights or patches that may address the issue.
  Data Consistency Checks: Regularly perform data consistency checks to identify and resolve potential conflicts before they lead to errors.
  Training and Documentation: Ensure that users involved in data entry are trained and have access to documentation to minimize data entry errors.
  
  By following these steps, you should be able to identify the cause of the error and implement a solution to resolve it.