How To Fix COM_ATTRFRG_GEN135 - Single value or value of lower limit cut off

SAP Error Message - Details

• Message type: E = Error

• Message class: COM_ATTRFRG_GEN - Message Class for Generating Attributes and Sets

• Message number: 135

• Message text: Single value or value of lower limit cut off

What causes this issue?

If an unsuitable attribute length is chosen, data is truncated in the
fields <ZK>Single Value or Lower Limit</> or <ZK>Upper Limit</> in the
<ZK>Value Range</> table. This occurs for the data types CHAR
(Character String), DEC (Decimal Number), or NUMC (Integer).

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Enter the data again after correcting the attribute length and save
your data.

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message COM_ATTRFRG_GEN135 - Single value or value of lower limit cut off ?

  The SAP error message COM_ATTRFRG_GEN135 typically indicates that there is an issue with the value being processed in a characteristic or attribute, specifically that a single value or a value at the lower limit has been cut off. This error often arises in the context of configuration or master data management, particularly when dealing with characteristics in variant configuration or classification.
  Cause:
  
  Value Range Issues: The value being entered or processed may fall outside the defined range for the characteristic. This can happen if the value is too low or if it does not meet the minimum requirements set in the configuration.
  Data Type Mismatch: The data type of the value being processed may not match the expected data type for the characteristic.
  Incorrect Configuration: The characteristic may not be properly configured to accept the value being assigned, leading to a cutoff.
  Missing Values: If a required value is missing or not properly defined, it can trigger this error.
  
  Solution:
  
  Check Value Ranges: Review the configuration of the characteristic to ensure that the value being entered falls within the acceptable range. Adjust the range if necessary.
  Validate Data Types: Ensure that the data type of the value being processed matches the expected data type for the characteristic. If there is a mismatch, correct it.
  Review Characteristic Configuration: Go through the configuration settings for the characteristic to ensure that it is set up correctly to accept the intended values.
  Input Correct Values: If the error is due to a missing or incorrect value, ensure that the correct values are being inputted and that all required fields are filled out.
  Consult Documentation: Refer to SAP documentation or help resources for specific guidance on the characteristic in question and any related configuration settings.
  
  Related Information:
  
  Transaction Codes: You may need to use transaction codes like CT04 (to maintain characteristics) or CU01 (to maintain configuration profiles) to check and modify the relevant settings.
  SAP Notes: Check for any relevant SAP Notes that may address this specific error or provide additional troubleshooting steps.
  Testing: After making changes, perform tests to ensure that the error no longer occurs and that the system behaves as expected.
  
  If the issue persists after following these steps, it may be beneficial to consult with an SAP expert or support team for further assistance.