How To Fix CNVHCM_PRESEL116 - Limit type &1 in step &2 does not exist; specify a valid limit type

SAP Error Message - Details

• Message type: E = Error

• Message class: CNVHCM_PRESEL - TDMS4HCM: Messages for Object Selection

• Message number: 116

• Message text: Limit type &1 in step &2 does not exist; specify a valid limit type

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message CNVHCM_PRESEL116 - Limit type &1 in step &2 does not exist; specify a valid limit type ?

  The SAP error message CNVHCM_PRESEL116 indicates that there is an issue with a limit type specified in a particular step of a process, likely related to the configuration of a compensation or payroll process in SAP HCM (Human Capital Management). The error message suggests that the limit type you are trying to use does not exist in the system.
  Cause:
  
  Non-existent Limit Type: The limit type specified in the configuration does not exist in the system. This could be due to a typo, or the limit type may not have been created or activated.
  Configuration Issues: The configuration settings for the compensation or payroll process may not be set up correctly, leading to the system not recognizing the limit type.
  Transport Issues: If the configuration was transported from another system, the limit type may not have been included in the transport request.
  
  Solution:
  
  Check Limit Type: Verify the limit type specified in the configuration. Ensure that it is correctly spelled and exists in the system. You can check this in the relevant configuration area (e.g., in the IMG under the relevant HCM module).
  Create/Activate Limit Type: If the limit type does not exist, you may need to create it or activate it in the system. This can typically be done in the configuration settings for the relevant module.
  Review Configuration: Go through the configuration steps related to the process you are working on (e.g., compensation planning, payroll) to ensure that all necessary settings are correctly defined.
  Transport Check: If the configuration was transported from another system, check the transport logs to ensure that all necessary objects, including limit types, were included in the transport request.
  Consult Documentation: Refer to SAP documentation or help resources for guidance on the specific configuration settings related to limit types in your version of SAP.
  
  Related Information:
  
  Transaction Codes: You may need to use transaction codes like SPRO (to access the IMG) or SE11 (to check table entries) to investigate further.
  SAP Notes: Check for any relevant SAP Notes that may address this specific error or provide additional guidance on limit types in your version of SAP.
  Support: If you are unable to resolve the issue, consider reaching out to your SAP support team or consulting with an SAP expert who specializes in HCM configurations.
  
  By following these steps, you should be able to identify the cause of the error and implement a solution to resolve it.