How To Fix CNV_PE_GEN107 - DDIC table type for data model parameter &1 not available

SAP Error Message - Details

• Message type: E = Error

• Message class: CNV_PE_GEN - Messages for object generation

• Message number: 107

• Message text: DDIC table type for data model parameter &1 not available

What causes this issue?

No (generated) DDIC table type was found for data model parameter <ZH>
&V1&</> (with ID: <ZH>&V2&</>).
<ZH>Technical Information</>
The technical identifier is: <ZH>&V3&</>

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message CNV_PE_GEN107 - DDIC table type for data model parameter &1 not available ?

  The SAP error message CNV_PE_GEN107 indicates that there is an issue with the Data Dictionary (DDIC) table type for a specific data model parameter in the context of a data migration or conversion process. This error typically arises during the execution of a conversion program, particularly in the context of SAP's data migration tools, such as the SAP S/4HANA Migration Cockpit or other data conversion scenarios.
  Cause:
  The error message suggests that the system is unable to find a defined DDIC table type for the specified data model parameter (&1). This can occur due to several reasons:
  
  Missing DDIC Definition: The required DDIC table type has not been created or is not available in the system.
  Incorrect Configuration: The data model parameter may be incorrectly configured or referenced in the migration program.
  Transport Issues: If the DDIC objects were transported from another system, there may have been issues during the transport that resulted in missing definitions.
  Version Compatibility: The version of the migration tool or the data model may not be compatible with the current system setup.
  
  Solution:
  To resolve the CNV_PE_GEN107 error, you can take the following steps:
  
  
  Check DDIC Definitions:
  
  Use transaction SE11 to check if the DDIC table type for the specified parameter exists. If it does not exist, you may need to create it or ensure it is properly defined.
  
  
  
  Review Configuration:
  
  Verify the configuration settings for the data model parameter in the migration tool. Ensure that all required parameters are correctly set up.
  
  
  
  Transport Check:
  
  If the DDIC objects were transported, check the transport logs for any errors or issues. You may need to re-transport the missing objects.
  
  
  
  Consult Documentation:
  
  Refer to the SAP documentation for the specific migration tool you are using. There may be additional steps or prerequisites that need to be fulfilled.
  
  
  
  System Update:
  
  Ensure that your SAP system is up to date with the latest support packages and notes, as there may be fixes related to this issue.
  
  
  
  Contact SAP Support:
  
  If the issue persists after checking the above points, consider reaching out to SAP Support for further assistance. Provide them with the error message details and any relevant logs.
  
  
  
  Related Information:
  
  Transaction Codes: SE11 (Data Dictionary), SE80 (Object Navigator), ST22 (Dump Analysis), SLG1 (Application Log).
  SAP Notes: Search for relevant SAP Notes in the SAP Support Portal that may address this specific error or provide additional guidance.
  Migration Tools: Familiarize yourself with the specific migration tool you are using, as each may have its own set of requirements and configurations.
  
  By following these steps, you should be able to identify the root cause of the CNV_PE_GEN107 error and implement a suitable solution.