How To Fix CNV_PE740 - Worklist parameter &1 has no corresponding parameter in data model &2

CNV_PE740 - Overview

• Message type: E = Error

• Message class: CNV_PE - General messages for posting engine

• Message number: 740

• Message text: Worklist parameter &1 has no corresponding parameter in data model &2

What causes this issue?

The worklist field is <ZH>not</> connected to a corresponding data model
field.
Hence, during selection, the worklist field is <ZH>not</> filled, but
remains empty.

System Response

Warning

How to fix this error?

Remove the worklist field and save your change. If required, add the
field again into the worklist.

Procedure for System Administrators

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Error message extract from SAP system. Copyright SAP SE.

CNV_PE740 - Details

• The SAP error message CNV_PE740 indicates that there is a mismatch between the parameters defined in the worklist and those available in the data model. This typically occurs during data migration or conversion processes, particularly when using SAP's tools for data migration, such as the SAP S/4HANA Migration Cockpit or other conversion tools.
  
  Cause:
  
  
  Parameter Mismatch: The worklist is trying to reference a parameter that does not exist in the specified data model. This can happen if:
  
  The data model has been changed or updated, and the worklist has not been synchronized with these changes.
  The worklist was created based on an outdated version of the data model.
  There are typographical errors in the parameter names.
  
  
  
  
  Configuration Issues: The configuration settings for the migration or conversion process may not be correctly set up, leading to discrepancies between the worklist and the data model.
  
  
  
  Solution:
  
  
  Check Parameter Definitions:
  
  Verify the parameters defined in the worklist and ensure they match those