How To Fix CNV_PE124 - Transformation type &1 for parameter &2 unknown/not supported

CNV_PE124 - Overview

• Message type: E = Error

• Message class: CNV_PE - General messages for posting engine

• Message number: 124

• Message text: Transformation type &1 for parameter &2 unknown/not supported

What causes this issue?

Transformation type <ZH>&V1&</> for parameter <ZH>&V2&</> is not
supported or is unknown.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Check and change the transformation settings of parameter <ZH>&V2&</>
accordingly.
Alternatively, in case the parameter is not required at all, you can
also delete (if allowed) the parameter from the transformation settings.
This means that the parameter is not taken into account while building
the <DS:TX.CNV_PE_TX_TRANSFER_LIST>transfer list</>.

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

CNV_PE124 - Details

• The SAP error message CNV_PE124 indicates that there is an issue with a transformation type for a specific parameter in a data conversion or migration process. This error typically arises during the execution of a data migration project, particularly when using SAP's Conversion Tools or Data Migration tools.
  
  Cause:
  
  Unknown Transformation Type: The transformation type specified for the parameter is not recognized by the system. This could be due to a typo, an outdated configuration, or a missing implementation.
  Unsupported Transformation: The transformation type may not be supported in the current context or version of the software you are using.
  
  Configuration Issues: There may be issues with the configuration settings in the migration tool or the source/target system.
  Missing Custom Code: If the transformation relies on custom code or enhancements that are not present in the system, this error can occur.
  
  
  Solution:
  
  Check Transformation Type: Verify that the transformation type specified for the parameter is correct. Look