How To Fix CNV_MBT_SNAP032 - Parameter &1 value &2 was already inserted in Parameter table.

CNV_MBT_SNAP032 - Overview

• Message type: E = Error

• Message class: CNV_MBT_SNAP - Messages for Snap Schor Integration

• Message number: 032

• Message text: Parameter &1 value &2 was already inserted in Parameter table.

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

CNV_MBT_SNAP032 - Details

• The SAP error message CNV_MBT_SNAP032 indicates that there is a duplicate entry for a parameter in the parameter table during a data migration or conversion process. This typically occurs in the context of using the SAP Migration Cockpit or other data migration tools where parameters are being set for the migration process.
  
  Cause:
  The error is caused by an attempt to insert a parameter value that already exists in the parameter table. This can happen due to:
  
  Duplicate entries being generated in the migration process.
  Incorrect configuration or setup of the migration parameters.
  A previous migration attempt that did not complete successfully, leaving behind residual data.
  
  
  Solution:
  To resolve this error, you can take the following steps:
  
  
  Check Existing Parameters:
  
  Review the parameter table to identify the existing entries. You can do this by accessing the relevant transaction or table in SAP (e.g., using SE11 or SE16).
  Look for the parameter &1 and its value &2 to confirm that it