How To Fix CNV_IUUC_REPLICATION313 - MT_ID &1: Table &2 is not in replication mode and cannot be adjusted

CNV_IUUC_REPLICATION313 - Overview

• Message type: E = Error

• Message class: CNV_IUUC_REPLICATION - IUUC replication messages (HANA)

• Message number: 313

• Message text: MT_ID &1: Table &2 is not in replication mode and cannot be adjusted

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

CNV_IUUC_REPLICATION313 - Details

• The SAP error message CNV_IUUC_REPLICATION313 MT_ID &1: Table &2 is not in replication mode and cannot be adjusted typically occurs in the context of SAP Landscape Transformation (SLT) or SAP Data Services when trying to replicate or adjust data in a table that is not set up for replication.
  
  Cause:
  
  Table Not in Replication Mode: The primary cause of this error is that the specified table (&2) is not configured for replication in the SLT system. This means that the table is either not included in the replication setup or has not been activated for replication.
  Incorrect Configuration: There may be a misconfiguration in the SLT settings or the table may have been excluded from the replication process.
  Replication Settings: The replication settings for the table might not have been properly defined, or the table might have been changed after the initial setup.
  
  
  Solution:
  
  
  Check Replication Configuration:
  
  Go to the SLT configuration transaction (usually LTRC).
  Check if the