How To Fix CNV_IUUC_REPL_TS053 - Latency data for table &1 is not available

CNV_IUUC_REPL_TS053 - Overview

• Message type: E = Error

• Message class: CNV_IUUC_REPL_TS - Messages for troubleshooting functions

• Message number: 053

• Message text: Latency data for table &1 is not available

What causes this issue?

There is not latency information in the system for table &V1&.

System Response

If the table is being loaded, this is normal.
If the table is being replicated, and table records were already
replicated within the last 24 hours, an error might be present in the
system functions that calculates and stores the latency data.

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

If the table is being replicated, contact you system administrator for
support.

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

CNV_IUUC_REPL_TS053 - Details

• The SAP error message CNV_IUUC_REPL_TS053 indicates that latency data for a specific table is not available. This error typically arises in the context of SAP Landscape Transformation (SLT) replication, where data is being replicated from a source system to a target system.
  
  Cause:
  
  
  Missing Latency Data: The error suggests that the system is unable to find the latency data for the specified table. This can occur if:
  
  The table has not been replicated yet.
  The replication process for the table has not been initialized.
  There are issues with the SLT configuration or the connection between the source and target systems.
  The table might have been excluded from replication.
  
  
  
  Technical Issues: There could be underlying technical issues such as:
  
  Network problems affecting the connection between the source and target systems.
  Configuration errors in the SLT setup.
  Incomplete or failed replication jobs.
  
  
  
  
  Solution:
  
  
  Check Replication Status: Verify the replication status of the table in question. You can do this by:
  
  Accessing the SLT configuration in