How To Fix CNV_IUUC_REPL_ADV_SE032 - Table &1 already added to "Table-Specific Settings"

SAP Error Message - Details

• Message type: E = Error

• Message class: CNV_IUUC_REPL_ADV_SE - MEssage class for package CNV_IUUC_REPL_ADV_SETTINGS

• Message number: 032

• Message text: Table &1 already added to "Table-Specific Settings"

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message CNV_IUUC_REPL_ADV_SE032 - Table &1 already added to "Table-Specific Settings" ?

  The SAP error message CNV_IUUC_REPL_ADV_SE032 indicates that a specific table (denoted by &1) has already been added to the "Table-Specific Settings" in the context of the SAP Landscape Transformation (SLT) replication process. This error typically arises during the configuration or setup of data replication from a source system to a target system.
  Cause:
  The error occurs because the system is trying to add a table to the replication settings that has already been configured. This can happen if:
  
  The table was previously added and not removed before attempting to add it again.
  There is a misconfiguration or duplication in the settings.
  
  Solution:
  To resolve this error, you can follow these steps:
  
  
  Check Existing Settings:
  
  Go to the SLT configuration transaction (usually LTRC).
  Navigate to the "Table-Specific Settings" section.
  Look for the table mentioned in the error message (&1) to confirm that it is already listed.
  
  
  
  Remove or Modify the Entry:
  
  If the table is indeed listed, you can either:
  
  Remove it if it is not needed.
  Modify the existing settings if you need to change the configuration for that table.
  
  
  
  
  
  Re-attempt the Operation:
  
  After confirming the table's status and making any necessary changes, re-attempt the operation that triggered the error.
  
  
  
  Check for Duplicates:
  
  Ensure that there are no duplicate entries for the same table in the settings. If duplicates exist, remove the unnecessary ones.
  
  
  
  Consult Documentation:
  
  If you are unsure about the settings or the implications of removing a table, consult the SAP documentation or reach out to your SAP Basis or SLT administrator for guidance.
  
  
  
  Related Information:
  
  Transaction Codes: Familiarize yourself with relevant transaction codes such as LTRC (SLT Configuration) and LTMC (Migration Cockpit) for managing replication settings.
  SAP Notes: Check for any SAP Notes related to SLT and the specific error message for additional troubleshooting steps or patches.
  SLT Documentation: Review the official SAP documentation on SLT for best practices in managing table-specific settings and replication configurations.
  
  By following these steps, you should be able to resolve the error and continue with your data replication tasks.