How To Fix CNV_DMC_SIN120 - Plant associated with main work center &1 is inital

SAP Error Message - Details

• Message type: E = Error

• Message class: CNV_DMC_SIN - Messages for s-innovations migration

• Message number: 120

• Message text: Plant associated with main work center &1 is inital

What causes this issue?

Plant associated with main work center is empty

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Senderfield "Plant associated with main work center" (WERGW) on item
level needs to be filled.

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message CNV_DMC_SIN120 - Plant associated with main work center &1 is inital ?

  The SAP error message CNV_DMC_SIN120 indicates that there is an issue with a plant associated with a main work center in the context of a data migration or conversion process. Specifically, the message states that the plant associated with the main work center is in an "initial" state, which typically means that it has not been fully configured or activated for use in the system.
  Cause:
  
  Incomplete Configuration: The plant may not have been fully set up in the system, which includes missing or incomplete data in the configuration settings.
  Inactive Status: The plant might be marked as inactive or not yet fully operational in the system.
  Data Migration Issues: If this error occurs during a data migration process, it could be due to missing or incorrect data mappings related to the work center and plant.
  
  Solution:
  
  
  Check Plant Configuration:
  
  Go to the SAP transaction code OX10 (or the relevant transaction for plant maintenance) and verify the configuration of the plant.
  Ensure that all necessary data is filled out, including the plant's status, address, and other relevant details.
  
  
  
  Activate the Plant:
  
  If the plant is inactive, you may need to activate it. This can usually be done in the same configuration area where you check the plant settings.
  
  
  
  Review Work Center Assignment:
  
  Check the assignment of the work center to the plant. Use transaction code CR01 (Create Work Center) or CR02 (Change Work Center) to ensure that the work center is correctly assigned to the plant.
  
  
  
  Data Migration Review:
  
  If this error arises during a data migration process, review the migration mapping and ensure that all required fields are correctly populated and that the plant is included in the migration data.
  
  
  
  Consult Documentation:
  
  Refer to SAP documentation or notes related to the specific error message for additional context and troubleshooting steps.
  
  
  
  Contact SAP Support:
  
  If the issue persists after checking the above points, consider reaching out to SAP support for further assistance, especially if this is part of a larger migration project.
  
  
  
  Related Information:
  
  Transaction Codes: OX10 (Plant Maintenance), CR01 (Create Work Center), CR02 (Change Work Center).
  SAP Notes: Check for any relevant SAP Notes that might address this specific error or provide additional troubleshooting steps.
  Data Migration Cockpit: If using the SAP Data Migration Cockpit, ensure that all prerequisites for the migration are met and that the data is correctly formatted.
  
  By following these steps, you should be able to resolve the CNV_DMC_SIN120 error and ensure that the plant associated with the main work center is properly configured and active.