How To Fix CNV_CMIS_U_20035 - Release vector was already set in the receiver client and is identical

SAP Error Message - Details

• Message type: E = Error

• Message class: CNV_CMIS_U_20 - CMIS Upg: Messages from XPRA functions

• Message number: 035

• Message text: Release vector was already set in the receiver client and is identical

What causes this issue?

The system detected that the release vector - necessary for the XPRA
execution - was already set in the receiver client. There are no
differences between the old and the new vector.

System Response

This is just for informative purposes; the upgrade is not stopped.

How to fix this error?

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message CNV_CMIS_U_20035 - Release vector was already set in the receiver client and is identical ?

  The SAP error message CNV_CMIS_U_20035 indicates that there is an issue related to the release vector in the context of a client conversion or migration process. This error typically arises during the execution of a conversion or migration project, particularly when using the SAP Conversion Management Information System (CMIS).
  Cause:
  The error message "Release vector was already set in the receiver client and is identical" suggests that the system is attempting to set a release vector in the target client, but it has already been set previously and is the same as the one being attempted. This can occur in scenarios such as:
  
  Duplicate Execution: The conversion or migration process is being executed multiple times, and the system is trying to apply the same release vector again.
  Configuration Issues: There may be a misconfiguration in the migration settings or parameters that leads to this situation.
  Client-Specific Settings: The target client may have already been configured with the necessary release vector, and the system is trying to apply it again.
  
  Solution:
  To resolve this error, you can take the following steps:
  
  
  Check Existing Release Vector: Verify the current release vector set in the target client. You can do this by checking the relevant configuration tables or using transaction codes that display client settings.
  
  
  Avoid Duplicate Execution: Ensure that the migration or conversion process is not being executed multiple times unnecessarily. If it has already been executed successfully, you may not need to run it again.
  
  
  Adjust Migration Parameters: If you are using a migration tool or program, review the parameters being passed to ensure they are correct and do not lead to redundant operations.
  
  
  Consult Documentation: Refer to the SAP documentation or notes related to the specific migration or conversion process you are performing. There may be specific instructions or prerequisites that need to be followed.
  
  
  Contact SAP Support: If the issue persists and you cannot identify the cause, consider reaching out to SAP Support for assistance. They may provide insights based on the specific context of your system and the migration process.
  
  
  Related Information:
  
  SAP Notes: Check for any relevant SAP Notes that might address this specific error or provide additional troubleshooting steps.
  Transaction Codes: Familiarize yourself with transaction codes related to client administration and migration, such as SCC4 (Client Administration) and SCCL (Client Copy).
  Migration Tools: If you are using specific SAP tools for migration (like SAP S/4HANA Migration Cockpit), ensure you are following the recommended procedures and guidelines.
  
  By following these steps, you should be able to diagnose and resolve the CNV_CMIS_U_20035 error effectively.