How To Fix CNV_20110002 - Not all CoCds participate in change &1 -> &2, COPY flag is not set.

SAP Error Message - Details

• Message type: E = Error

• Message class: CNV_20110 - Pre-analysis for chart of accounts conversion

• Message number: 002

• Message text: Not all CoCds participate in change &1 -> &2, COPY flag is not set.

What causes this issue?

According to your mapping table you want to change the chart of
accounts ID &V1& into &V2&.
However not all company codes that use this chart of accounts &V1&
participate in the conversion.
In addition, the COPY indicator is not set.

System Response

If the chart of accounts ID is changed, but not all company codes that
use the chart of accounts participate in the chart of accounts
conversion, the COPY indicator must be set.
Otherwise, the master data of chart of accounts &V1& would be
completely converted into &V2&, so that they would no longer be
available to the non-participating company codes (that are still meant
to use chart of accounts &V1&) after the conversion. As a consequence,
the non-participating company codes could no longer be used.

How to fix this error?

Decide if you want to add the missing company codes in the mapping or
to set the COPY indicator.
Maintain the mapping table accordingly.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message CNV_20110002 - Not all CoCds participate in change &1 -> &2, COPY flag is not set. ?

  The SAP error message CNV_20110002 typically occurs during a data migration or conversion process, particularly when using the SAP S/4HANA Migration Cockpit or similar tools. This error indicates that not all Company Codes (CoCds) are participating in the change process, and the COPY flag is not set for the relevant entries.
  Cause:
  
  Inconsistent Configuration: The error often arises when there are inconsistencies in the configuration of the Company Codes involved in the migration. Some Company Codes may not be set up to participate in the change process.
  Missing COPY Flag: The COPY flag is a setting that allows certain data to be copied from one Company Code to another. If this flag is not set for the relevant Company Codes, the system will not allow the operation to proceed.
  Data Migration Settings: The settings in the migration cockpit or the data migration tool may not be correctly configured to include all necessary Company Codes.
  
  Solution:
  
  Check Company Code Configuration: Review the configuration of the Company Codes involved in the migration. Ensure that all relevant Company Codes are correctly set up to participate in the change process.
  Set the COPY Flag: If applicable, ensure that the COPY flag is set for the relevant entries. This may involve adjusting settings in the migration tool or the underlying data structures.
  Review Migration Settings: Go through the migration settings in the SAP S/4HANA Migration Cockpit or the relevant data migration tool. Ensure that all necessary Company Codes are included in the migration process.
  Consult Documentation: Refer to the SAP documentation for the specific migration tool you are using. There may be additional steps or configurations required to resolve this issue.
  Testing: After making the necessary changes, perform a test migration to ensure that the error does not occur again.
  
  Related Information:
  
  SAP Notes: Check for any relevant SAP Notes that may address this specific error or provide additional guidance on resolving it.
  SAP Community: Engage with the SAP Community forums to see if other users have encountered similar issues and what solutions they have found.
  Migration Cockpit Documentation: Review the official SAP documentation for the Migration Cockpit, as it may provide insights into common issues and their resolutions.
  
  If the problem persists after following these steps, it may be beneficial to consult with an SAP expert or support for further assistance.