How To Fix CNV_10100200 - Set class &1 not present in table CNV_10100_SETCLA;no conversion possible

CNV_10100200 - Overview

• Message type: E = Error

• Message class: CNV_10100 - Messages from package 10100

• Message number: 200

• Message text: Set class &1 not present in table CNV_10100_SETCLA;no conversion possible

What causes this issue?

The system checks the conversion Customizing for all available set
classes in the system. The required Customizing in table
CNV_10100_SETCLA is not available for set class &V1&.

System Response

The system cannot convert the sets of set class &V1&. If set class &V1&
is not affected by this conversion package, you can ignore this message.

How to fix this error?

If the set class should be included in the conversion, provide a
complete Customizing for set class &V1& in table CNV_10100_SETCLA. The
following fields are relevant:
SET_TABLE
VALUE_FIELD
SUBCLASS_TABLE
SUBCLASS_FIELD

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

If the set class is not relevant for the conversion, mark the field
IGNORE_SETCLASS.
Note that this table is a cross client table, and the Customizing
settings are used for all clients.
To convert this set class, provide the complete Customizing settings
with the implemented interface and methods in table CNV_10100_SETCON.
You can only assign one application package to each set class and
relation type.

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

CNV_10100200 - Details

• The SAP error message CNV_10100200 indicates that a specific set class (identified by &1) is not present in the table CNV_10100_SETCLA, which is part of the SAP Conversion Tools. This error typically occurs during data migration or conversion processes, particularly when using the SAP S/4HANA Migration Cockpit or other data migration tools.
  
  Cause:
  
  
  Missing Set Class: The set class that the system is trying to reference does not exist in the CNV_10100_SETCLA table. This could be due to:
  
  The set class not being defined in the system.
  The set class being deleted or not properly imported during a migration process.
  A mismatch between the data being processed and the expected configuration in the system.
  
  
  
  
  Configuration Issues: There may be configuration issues in the migration settings or the source data that lead to the system looking for a non-existent set class.
  
  
  
  Solution:
  
  
  Check Set Class Definition:
  
  Verify if the set class exists in the CNV_10100_SETCLA table. You can do this