How To Fix CNV_10030053 - Dependent package &1 cannot be assigned to package &2; TDetObj &3 missing

CNV_10030053 - Overview

• Message type: E = Error

• Message class: CNV_10030 - Message class for package 10030

• Message number: 053

• Message text: Dependent package &1 cannot be assigned to package &2; TDetObj &3 missing

What causes this issue?

&V1& is defined as a dependent package of &V2& in the table CNVPACKDP.
According to the org. settings for package &V1&, this package <zh>does
not</> inherit the target determination objects from package &V2&. &V3&
is defined as a target determination object for package &V2&, but not
for package &V1&.

System Response

Package &V1& is considered as a package in its own right. Because it
depends on package &V2&, however, it is <zh>not</> considered as the
main source package. This means that for package &V1& it is not possible
to specify relevant values for a delimitation that may be required. Any
values that may have been defined for package &V2& <zh>do not</> apply
to package &V1&.

How to fix this error?

The most likely reason for this is that the org. settings were not
maintained correctly during definition of package dependencies.
Dependent packages should always inherit the org. settings of their
higher-level package. If this setting is not possible in a concrete
case, the two packages should at least have the same target
determination objects.
If you consider the org. settings as acceptable the way they are, no
further action is required.
&HINTS&

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

You maintain the org. settings for a package in the transaction
CNV_10020_TDTOBJ. <zh>Consider also the documentation for this
transaction.</>
To find out about org.-specific package dependencies of the blended
package, use transaction CNV_10030_SCENARIO.

Error message extract from SAP system. Copyright SAP SE.

CNV_10030053 - Details

• The SAP error message CNV_10030053 typically occurs during the process of data migration or conversion, particularly when using the SAP S/4HANA Migration Cockpit or similar tools. This error indicates that there is a problem with the assignment of dependent packages in the context of data migration.
  
  Cause:
  The error message states that a dependent package (identified as &1) cannot be assigned to another package (identified as &2) because a required object (identified as &3) is missing. This usually happens due to one of the following reasons:
  
  
  Missing Dependencies: The dependent package may have certain prerequisites or dependencies that are not fulfilled. This could be due to missing data objects or configuration settings that are required for the migration process.
  
  
  Incorrect Configuration: There might be an issue with the configuration of the migration packages, where the dependencies are not correctly defined or linked.
  
  
  Data Integrity Issues: If the data being migrated has integrity issues or is