How To Fix CNV20200760 - Select start and end of block

SAP Error Message - Details

• Message type: E = Error

• Message class: CNV20200 - Messages for development class CNV_20200

• Message number: 760

• Message text: Select start and end of block

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message CNV20200760 - Select start and end of block ?

  The SAP error message CNV20200760, which states "Select start and end of block," typically occurs during data migration or conversion processes, particularly when using the SAP S/4HANA Migration Cockpit or similar tools. This error indicates that the system requires the user to specify a start and end point for a block of data that is being processed.
  Cause:
  
  Missing Input: The user has not specified the start and end of the block of data that needs to be processed.
  Incorrect Configuration: The migration or conversion settings may not be properly configured, leading to the system not recognizing the required parameters.
  Data Selection Issues: The selection criteria for the data block may not be correctly defined, causing the system to be unable to identify the data range.
  
  Solution:
  
  Specify Start and End Points: Ensure that you have selected the appropriate start and end points for the data block you are trying to process. This may involve entering specific values or selecting them from a list.
  Check Configuration Settings: Review the configuration settings in the migration tool to ensure that all required parameters are correctly set.
  Review Data Selection Criteria: Make sure that the criteria used to select the data block are valid and correctly defined. This may involve checking filters or conditions applied to the data.
  Consult Documentation: Refer to the official SAP documentation or guides related to the specific migration or conversion process you are using. This can provide insights into the required steps and parameters.
  Seek Support: If the issue persists, consider reaching out to SAP support or consulting with a technical expert who has experience with the specific migration tool you are using.
  
  Related Information:
  
  SAP Notes: Check for any relevant SAP Notes that may address this specific error or provide additional troubleshooting steps.
  Migration Cockpit Documentation: Review the documentation for the SAP S/4HANA Migration Cockpit or the specific tool you are using for data migration, as it may contain specific instructions related to this error.
  Community Forums: Engage with SAP community forums or user groups where similar issues may have been discussed, and solutions shared.
  
  By following these steps, you should be able to resolve the CNV20200760 error and successfully proceed with your data migration or conversion process.