How To Fix CMX_XS121 - Characteristic for parameter &1 and reference parameter &2 do not match

CMX_XS121 - Overview

• Message type: E = Error

• Message class: CMX_XS - XSteps: Messages

• Message number: 121

• Message text: Characteristic for parameter &1 and reference parameter &2 do not match

What causes this issue?

The characteristics for
<DS:GLOS.791AAC106C8540438B4B3453B90FB611>parameter</> &V1& and the
referenced parameter &V2& do not match. In the case of parameter
references, the characteristics of both parameters must be the same.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Check and change, if necessary, the characteristic in the parameter &V1&
of the current <DS:GLOS.463635950E355841B1F5F8904C71718F>XStep</> and in
the parameter &V2& of the higher-level XStep.

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

CMX_XS121 - Details

• The SAP error message CMX_XS121 indicates that there is a mismatch between the characteristics of a parameter and a reference parameter in the context of configuration management. This error typically arises in scenarios involving configurable materials or products, where certain characteristics must align between the parameters being used.
  
  Cause:
  The error occurs when:
  
  Inconsistent Characteristics: The characteristics defined for a specific parameter do not match those defined for the reference parameter. This can happen if the configuration settings for the parameters are not aligned.
  Incorrect Configuration: The configuration of the material or product may have been set up incorrectly, leading to discrepancies in the expected characteristics.
  Data Entry Errors: Manual entry errors during the configuration process can lead to mismatched characteristics.
  
  
  Solution:
  To resolve the CMX_XS121 error, you can take the following steps:
  
  
  Check Parameter Definitions:
  
  Review the definitions of both the parameter (&1) and the reference parameter (&2). Ensure that the characteristics assigned to both parameters are consistent