Message type: E = Error
Message class: CMS - KPro: Content Management Service
Message number: 161
Message text: Location &3 is passed more than once in path from &1 to &2
In the access path from the location &v1& to location &v2&, the
location &V3& is being passed repeatedly. Access paths must not contain
cycles.
The system issues an error message and will not allow you to continue with this transaction until the error is resolved.
Correct the Customizing (<DS:TRAN.SCMSLP>Define paths</>).
Error message extract from SAP system. Copyright SAP SE.
CMS161
- Location &3 is passed more than once in path from &1 to &2 ?The SAP error message CMS161 indicates that a location (in this case, a specific node or object in a system path) has been referenced more than once in a path from one point to another. This typically occurs in the context of system configurations, such as in the SAP Change Management System (CMS) or when dealing with transport routes.
Cause: The error is caused by a circular reference or duplication in the path definition. This can happen if: A location is incorrectly configured in the transport route. There are multiple entries for the same location in the path. The system is trying to resolve a path that leads back to a previously visited location, creating a loop.
Solution: To resolve the CMS161 error, you can follow these steps: Check the Transport Route Configuration: Go to the transaction code STMS (Transport Management System). Navigate to the transport routes and check the configuration for the specific path from &1 to &2. Ensure that
Get instant SAP help. Sign up for our Free Essentials Plan.
CMS160
Index &3 Missing from Path from &1 to &2
What causes this issue? The index &v3& is missing in the access path from the location &v1& to &v2&. When you define access p...
CMS159
Path from &1 to &2 Begins with Index &3
What causes this issue? The access path from the location &v1& to location &v2& begins with index &v3&. When you define acces...
CMS162
Location &1 for network mask &2 redundant for network mask &3
What causes this issue? The Customizing specifies that subnets &v2& and &v3& are found at location &v1&. Since the subnet &am...
CMS163
For &1 users, location is driven using LCA parameters
What causes this issue? The parameter <ls>LCA</> is pre-set in the user settings for &v1& users. This enables all location-depend...
Click on this link to search all SAP messages.