How To Fix CM_SUB_API007 - Specification &1 contains too-high composition values for spec. &2

SAP Error Message - Details

• Message type: E = Error

• Message class: CM_SUB_API - API Substance

• Message number: 007

• Message text: Specification &1 contains too-high composition values for spec. &2

What causes this issue?

In the composition hierarchy tree, the specification &V1& contains
values for the direct or indirect component &V2& that are too great.
When searching via components, only values that are less than 99 or
9900% are taken into account because conversion errors may otherwise
occur as a result of the calculations. Upper limits, lower limits, and
average values that are greater than 99 are set internally to 99 and
this value is used to continue calculation.

System Response

You can run the search, but the search result may possibly contain
errors owing to the values that were too great.

How to fix this error?

Remove values greater than 99 by correcting the compositions of the
specifications.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message CM_SUB_API007 - Specification &1 contains too-high composition values for spec. &2 ?

  The SAP error message CM_SUB_API007 indicates that there are composition values in a specification that exceed the allowed limits for a particular material or product. This error typically arises in the context of SAP's Product Safety and Compliance Management (PSCM) or in the context of Material Management (MM) when dealing with specifications and their associated composition values.
  
  Cause:
  
  Exceeding Composition Limits: The composition values defined in the specification (spec. &1) for a material exceed the maximum allowable limits defined in the reference specification (spec. &2).
  Incorrect Data Entry: There may have been an error in data entry where the composition values were incorrectly inputted.
  Specification Changes: Changes in regulations or internal policies may have altered the acceptable limits for certain compositions, leading to discrepancies.
  
  Configuration Issues: There may be issues with the configuration of the material master or specification management settings that are causing incorrect validation.
  
  
  Solution:
  
  Review Composition Values: Check the composition values in the specification