How To Fix CM_REPORT_DEFPARA101 - Report symbol group &1 is not defined in Customizing

CM_REPORT_DEFPARA101 - Overview

• Message type: E = Error

• Message class: CM_REPORT_DEFPARA - Reports - Determining Default Parameter Values

• Message number: 101

• Message text: Report symbol group &1 is not defined in Customizing

What causes this issue?

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

System Response

How to fix this error?

INCLUDE EHS_NA_ADMIN OBJECT DOKU ID TX

Procedure for System Administrators

INCLUDE EHS_NA_CHECK_CUSTOMIZING OBJECT DOKU ID TX

Error message extract from SAP system. Copyright SAP SE.

CM_REPORT_DEFPARA101 - Details

• The SAP error message CM_REPORT_DEFPARA101 indicates that a report symbol group specified in your configuration is not defined in the Customizing settings. This typically occurs when a report or a program is trying to access a symbol group that has not been set up in the system.
  
  Cause:
  
  Missing Configuration: The symbol group referenced in the report is not defined in the Customizing settings.
  Incorrect Symbol Group Name: There may be a typo or incorrect name used for the symbol group in the report.
  Transport Issues: If the configuration was transported from another system, the transport might not have included the necessary symbol group definitions.
  Authorization Issues: Sometimes, the user may not have the necessary authorizations to access the symbol group.
  
  
  Solution:
  
  
  Check Customizing Settings:
  
  Go to the Customizing transaction (SPRO) and navigate to the relevant area where symbol groups are defined.
  Ensure that the symbol group mentioned in the error message is created and properly configured.
  
  
  
  Verify Symbol Group