How To Fix CM_MDQLTYRULEMINING024 - Field &2 of table &1 can either be used in focus area or selected fields.

SAP Error Message - Details

• Message type: E = Error

• Message class: CM_MDQLTYRULEMINING - Messages for Rule Mining Run

• Message number: 024

• Message text: Field &2 of table &1 can either be used in focus area or selected fields.

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message CM_MDQLTYRULEMINING024 - Field &2 of table &1 can either be used in focus area or selected fields. ?

  The SAP error message CM_MDQLTYRULEMINING024 indicates that there is a conflict in the configuration of a data quality rule, specifically regarding the use of fields in a focus area or selected fields. This error typically arises in the context of data quality management, particularly when defining rules for data mining or data quality checks.
  Cause:
  The error occurs when a field (denoted as &2) in a specified table (denoted as &1) is being used in both the focus area and the selected fields simultaneously. In SAP, a field can either be part of the focus area (which defines the scope of the data quality rule) or be explicitly selected for processing, but not both at the same time.
  Solution:
  To resolve this error, you need to ensure that the field in question is only used in one of the two contexts (focus area or selected fields). Here are the steps you can take:
  
  
  Review the Configuration: Go to the configuration settings for the data quality rule where the error is occurring. Check the definitions of the focus area and the selected fields.
  
  
  Modify the Focus Area or Selected Fields:
  
  If the field is currently in the focus area, consider removing it from the selected fields.
  Conversely, if the field is in the selected fields, you may need to remove it from the focus area.
  
  
  
  Save Changes: After making the necessary adjustments, save your changes and try to execute the data quality rule again.
  
  
  Test the Configuration: Run a test to ensure that the data quality rule works as expected without triggering the error.
  
  
  Related Information:
  
  Documentation: Refer to the SAP documentation for data quality management and rule configuration for more detailed guidance on setting up focus areas and selected fields.
  SAP Notes: Check for any relevant SAP Notes that might provide additional insights or updates related to this error message.
  Community Forums: Consider visiting SAP community forums or support channels where similar issues may have been discussed, and solutions shared by other users.
  
  By following these steps, you should be able to resolve the CM_MDQLTYRULEMINING024 error and successfully configure your data quality rules in SAP.