How To Fix CM_EHHSS_RAS_COMMON062 - There are no controls assigned to the selected hazard &1

SAP Error Message - Details

• Message type: E = Error

• Message class: CM_EHHSS_RAS_COMMON - Common Messages for Risk Assessment

• Message number: 062

• Message text: There are no controls assigned to the selected hazard &1

What causes this issue?

You wanted to add controls for a selected hazard. However, there are no
controls specified for this hazard.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

You can do one of the following:
Ensure that you have selected the correct hazard, and try adding
controls again.
Contact your system administrator.

Procedure for System Administrators

Ensure the following:
In Customizing activity <DS:SIMG.EHHSS_RAS_HAZREG>Configure Hazard and
Control Register</>, the required control catalogs have been specified
and assigned to the hazard &V1& (hazard category &V2&).
In the application, the required controls have been created for the
control catalog.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message CM_EHHSS_RAS_COMMON062 - There are no controls assigned to the selected hazard &1 ?

  The SAP error message CM_EHHSS_RAS_COMMON062, which states "There are no controls assigned to the selected hazard &1," typically occurs in the context of the SAP Environment, Health, and Safety (EHS) module. This error indicates that the system cannot find any controls (preventive measures, safety measures, etc.) associated with the specified hazard.
  
  Cause:
  
  Missing Control Assignments: The most common cause is that the hazard in question does not have any controls assigned to it in the system.
  
  Configuration Issues: There may be issues with the configuration of the hazard and control management settings in SAP EHS.
  Data Entry Errors: There could be errors in data entry where the controls were not properly linked to the hazard.
  Authorization Issues: Sometimes, the user may not have the necessary authorizations to view or assign controls to hazards.
  
  
  Solution:
  
  
  Check Control Assignments:
  
  Navigate to the hazard in question and verify if any controls are assigned. If not, you will need to create and