How To Fix CM_EHHSS_CINSP_COMN001 - Select at least one control instance for the control inspection

SAP Error Message - Details

• Message type: E = Error

• Message class: CM_EHHSS_CINSP_COMN - Common Messages for Control Inspecitons

• Message number: 001

• Message text: Select at least one control instance for the control inspection

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message CM_EHHSS_CINSP_COMN001 - Select at least one control instance for the control inspection ?

  The SAP error message CM_EHHSS_CINSP_COMN001 ("Select at least one control instance for the control inspection") typically occurs in the context of the SAP Environment, Health, and Safety (EHS) module, particularly when dealing with control inspections.
  Cause:
  This error message indicates that the system requires at least one control instance to be selected for the control inspection process. Control instances are specific instances of controls that are being monitored or inspected, and if none are selected, the system cannot proceed with the inspection.
  Solution:
  To resolve this error, follow these steps:
  
  
  Navigate to the Control Inspection Screen: Go to the relevant transaction or screen where you are trying to perform the control inspection.
  
  
  Select Control Instances: Look for a section or table where control instances are listed. Ensure that you select at least one control instance. This may involve checking checkboxes or selecting from a dropdown menu.
  
  
  Check for Filters: If you do not see any control instances available for selection, check if there are any filters applied that might be hiding the instances. Clear or adjust the filters as necessary.
  
  
  Review Control Instances Configuration: If you believe there should be control instances available but they are not showing up, verify that the control instances have been properly configured and are active in the system.
  
  
  Save and Retry: After selecting the control instance(s), save your changes and try to proceed with the control inspection again.
  
  
  Related Information:
  
  
  User Authorization: Ensure that you have the necessary authorizations to view and select control instances. Lack of permissions can sometimes lead to instances not being displayed.
  
  
  Documentation: Refer to the SAP EHS documentation for more detailed information on control inspections and how to manage control instances.
  
  
  SAP Notes: Check the SAP Support Portal for any relevant SAP Notes that might address this specific error or provide additional troubleshooting steps.
  
  
  Consult with Colleagues or SAP Support: If the issue persists, consider reaching out to your SAP support team or consulting with colleagues who have experience with the EHS module.
  
  
  By following these steps, you should be able to resolve the error and successfully select control instances for your control inspection.