How To Fix CM_EHFND_FW_CALC_ENG024 - Calculation result unit "&1" (&2) differs from calculated unit "&3" (&4)

SAP Error Message - Details

• Message type: E = Error

• Message class: CM_EHFND_FW_CALC_ENG - Common ACE Calculation Engine Exception Class

• Message number: 024

• Message text: Calculation result unit "&1" (&2) differs from calculated unit "&3" (&4)

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message CM_EHFND_FW_CALC_ENG024 - Calculation result unit "&1" (&2) differs from calculated unit "&3" (&4) ?

  The SAP error message CM_EHFND_FW_CALC_ENG024 indicates a discrepancy between the expected unit of measure for a calculation and the actual unit of measure that was used. This error typically arises in scenarios involving calculations in the SAP system, particularly in the context of financial or material management where units of measure are critical.
  
  Cause:
  The error occurs when the system calculates a value using a specific unit of measure, but the result is in a different unit than what was anticipated. This can happen due to several reasons:
  
  
  Configuration Issues: Incorrect configuration of units of measure in the system.
  Data Entry Errors: Manual entry of data that does not conform to the expected units.
  Master Data Issues: Problems with the master data, such as incorrect unit definitions for materials or products.
  Conversion Factors: Incorrect or missing conversion factors between different units of measure.
  
  
  Solution:
  To resolve this error, you can take the following steps:
  
  
  Check Configuration:
  
  Review the configuration settings