How To Fix CM_EHENV_SCEN_SETUP009 - Specified unit does not match chemical property &1

CM_EHENV_SCEN_SETUP009 - Overview

• Message type: E = Error

• Message class: CM_EHENV_SCEN_SETUP -

• Message number: 009

• Message text: Specified unit does not match chemical property &1

What causes this issue?

You want to assign a unit to a chemical property but the specified unit
does not match the units that are allowed for the concrete chemical
property.

System Response

The application does not allow you to assign the unit to that chemical
property.

How to fix this error?

Either provide a unit that is relevant for the concrete chemical
property, or configure a relevant unit in Customizing, under the
following activity: <LS>Environment, Health, and Safety -> Environment
Management -> Master Data Configuration -> Specify Chemical Properties.
</>

Procedure for System Administrators

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message CM_EHENV_SCEN_SETUP009 - Specified unit does not match chemical property &1 ?

  The SAP error message CM_EHENV_SCEN_SETUP009 indicates that there is a mismatch between the specified unit of measure and the expected unit for a chemical property in the context of Environmental Health and Safety (EHS) or Product Safety Management.
  
  Cause:
  This error typically arises when:
  
  The unit of measure (UoM) specified for a chemical property does not align with the expected UoM defined in the system for that particular property.
  The configuration of the chemical properties in the system may not be set up correctly, leading to discrepancies in expected units.
  The data entry for the chemical property may have been incorrectly inputted, leading to a mismatch.
  
  
  Solution:
  To resolve this error, you can take the following steps:
  
  
  Check the Chemical Property Configuration:
  
  Navigate to the configuration settings for the chemical properties in SAP.
  Verify the expected unit of measure for the specific chemical property that is causing the error.
  
  
  
  Review the Data Entry:
  
  Go back to the data entry screen where the