How To Fix CM_EHENV_SCEN039 - Cannot delete; the calculation results are used in activities

CM_EHENV_SCEN039 - Overview

• Message type: E = Error

• Message class: CM_EHENV_SCEN - Compliance Scenario Messages

• Message number: 039

• Message text: Cannot delete; the calculation results are used in activities

What causes this issue?

You are trying to delete calculations which are used in other compliance
scenario activities.

System Response

The system does not allow deleting of calculations with results that are
in use in other compliance scenario activities.

How to fix this error?

Make sure the amounts of the calculation results are removed and any
errors are resolved. Retry deleting the calculations.

Procedure for System Administrators

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message CM_EHENV_SCEN039 - Cannot delete; the calculation results are used in activities ?

  The SAP error message CM_EHENV_SCEN039 indicates that you are trying to delete a calculation scenario or environment that is currently being used in one or more activities. This is a common issue in SAP when there are dependencies that prevent the deletion of certain objects.
  
  Cause:
  The primary cause of this error is that the calculation results from the scenario you are attempting to delete are still referenced or utilized in other activities or processes within the system. This could include:
  
  Active projects or simulations that rely on the calculation results.
  Reports or analyses that are using the data generated by the calculation scenario.
  Other dependent scenarios or calculations that are linked to the one you are trying to delete.
  
  
  Solution:
  To resolve this error, you can follow these steps:
  
  
  Identify Dependencies:
  
  Check which activities or processes are using the calculation results. You may need to review the configuration or settings in the relevant modules to find out where