How To Fix CM_CBESCOM053 - Specification &3: No interval intended in characteristic &1 for ESComXML

CM_CBESCOM053 - Overview

• Message type: E = Error

• Message class: CM_CBESCOM - Message Class for ESComXML Outbound Processing

• Message number: 053

• Message text: Specification &3: No interval intended in characteristic &1 for ESComXML

Schirmnachricht Nummer 081

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

What causes this issue?

An interval has been entered in the characteristic &V1& (&V2&) in value
assignment type &V4& of specification &V3&. An interval should not be
used at this point in the ESComXML file.

System Response

The system only transfers the upper value of the interval to the
corresponding attribute of the ESComXML file.

How to fix this error?

Check the data of the characteristic &V1&(&V2&) of specification &V3&
and remove the interval.

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message CM_CBESCOM053 - Specification &3: No interval intended in characteristic &1 for ESComXML ?

  The SAP error message CM_CBESCOM053 indicates that there is an issue with the specification of a characteristic in the context of ESComXML (Enterprise Services Communication XML). Specifically, the error states that there is "No interval intended" for a characteristic that is expected to have an interval defined.
  
  Cause:
  This error typically arises when:
  
  A characteristic is defined in a specification but does not have an interval set, which is required for the processing of certain data types or operations.
  The characteristic is expected to have a range of values (an interval) but is incorrectly configured to not allow for that.
  There may be a mismatch between the expected data structure in the XML and the actual configuration in the SAP system.
  
  
  Solution:
  To resolve this error, you can take the following steps:
  
  
  Check Characteristic Configuration:
  
  Go to the relevant specification in the SAP system and check the configuration of the characteristic mentioned in the error message.
  Ensure that the characteristic