How To Fix CI_DRAFTPRD_MESSAGE713 - Unit &1 of class &2 cannot be converted to unit of product &3

SAP Error Message - Details

• Message type: E = Error

• Message class: CI_DRAFTPRD_MESSAGE -

• Message number: 713

• Message text: Unit &1 of class &2 cannot be converted to unit of product &3

What causes this issue?

One of the unit of measures of the product must be capable of conversion
to the base unit of measure in the additional data of the class.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Check the base unit of measure defined in the additional data of the
class for its classified products. For the product, enter a unit that is
capable of conversion to this unit.
If you cannot do this, define another class that supports products with
this unit of measure.

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message CI_DRAFTPRD_MESSAGE713 - Unit &1 of class &2 cannot be converted to unit of product &3 ?

  The SAP error message CI_DRAFTPRD_MESSAGE713 indicates that there is an issue with unit conversion in the context of product data management. Specifically, it states that a unit of measure (UoM) for a certain class cannot be converted to the unit of measure of a product. This typically occurs in scenarios involving material master data, product variants, or when dealing with product drafts.
  Cause:
  
  
  Incompatible Units of Measure: The unit of measure for the item you are trying to convert is not compatible with the unit of measure defined for the product. This can happen if the units belong to different measurement systems (e.g., metric vs. imperial).
  
  
  Missing Conversion Factors: There may not be a defined conversion factor between the two units of measure in the system. SAP requires that all units of measure have a defined conversion relationship.
  
  
  Incorrect Configuration: The configuration settings for units of measure in the material master or product class may not be set up correctly.
  
  
  Data Entry Errors: There may be a mistake in the data entry where the wrong unit of measure is being used.
  
  
  Solution:
  
  
  Check Unit of Measure Settings: Verify the unit of measure settings for both the product and the item you are trying to convert. Ensure that they are compatible and that the necessary conversion factors are defined.
  
  
  Define Conversion Factors: If the conversion factor is missing, you can define it in the SAP system. This can typically be done in the material master data under the "Units of Measure" section.
  
  
  Review Material Master Data: Go to the material master record for the product and check the units of measure assigned. Ensure that the base unit of measure and any alternative units of measure are correctly configured.
  
  
  Check Configuration: Review the configuration settings in the relevant customizing transactions (e.g., SPRO) to ensure that the units of measure are set up correctly for the product class.
  
  
  Data Validation: Ensure that the data being entered is correct and that the appropriate units of measure are being used.
  
  
  Consult Documentation: If the issue persists, consult SAP documentation or reach out to your SAP support team for further assistance.
  
  
  Related Information:
  
  Transaction Codes: You may need to use transaction codes like MM03 (Display Material), MM02 (Change Material), or MM01 (Create Material) to check or modify material master data.
  Unit of Measure Configuration: The configuration for units of measure can be found under the Logistics General settings in the SAP customizing (SPRO).
  SAP Notes: Check for any relevant SAP Notes that may address this specific error or provide additional guidance.
  
  By following these steps, you should be able to identify the cause of the error and implement a solution to resolve it.