How To Fix CI_DRAFTPRD_MESSAGE135 - Planning product/plant is itself planned via & &

SAP Error Message - Details

• Message type: E = Error

• Message class: CI_DRAFTPRD_MESSAGE -

• Message number: 135

• Message text: Planning product/plant is itself planned via & &

What causes this issue?

A planning product has already been assigned to the combination of
planning product and planning plant that you have entered. The product
concerned is in plant . The system allows only single-level planning.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message CI_DRAFTPRD_MESSAGE135 - Planning product/plant is itself planned via & & ?

  The SAP error message CI_DRAFTPRD_MESSAGE135 typically occurs in the context of planning in SAP, particularly when dealing with planning products and plants in the SAP Integrated Business Planning (IBP) or Advanced Planning and Optimization (APO) modules. This error indicates that there is a circular dependency in the planning process, where a product or plant is being planned in a way that it references itself, leading to a conflict.
  Cause:
  The error is caused by a situation where:
  
  A planning product or plant is set up in such a way that it is dependent on itself for planning.
  This can happen due to incorrect configuration in the planning hierarchy or planning parameters.
  It may also occur if there are incorrect settings in the planning book or if the planning sequence is not properly defined.
  
  Solution:
  To resolve this error, you can take the following steps:
  
  
  Check Planning Parameters: Review the planning parameters for the product/plant in question. Ensure that there are no self-references in the planning setup.
  
  
  Review Planning Books: Examine the planning books and the key figures used. Make sure that the key figures do not reference themselves or create a circular dependency.
  
  
  Adjust Planning Hierarchy: If you are using a planning hierarchy, ensure that the hierarchy is correctly defined and does not create circular references.
  
  
  Check Master Data: Verify the master data for the product and plant. Ensure that there are no incorrect entries that could lead to self-referencing.
  
  
  Consult Documentation: Refer to SAP documentation or help resources for specific guidance on the configuration of planning products and plants.
  
  
  Testing: After making changes, test the planning process again to ensure that the error is resolved.
  
  
  Seek Help from SAP Support: If the issue persists, consider reaching out to SAP support for further assistance, providing them with detailed information about the configuration and the error message.
  
  
  Related Information:
  
  SAP Notes: Check for any relevant SAP Notes that might address this specific error or provide additional troubleshooting steps.
  Community Forums: Engage with SAP community forums or user groups where similar issues may have been discussed.
  Training and Documentation: Ensure that users involved in planning are adequately trained on the system and understand how to configure planning products and plants correctly.
  
  By following these steps, you should be able to identify and resolve the cause of the CI_DRAFTPRD_MESSAGE135 error in your SAP system.