How To Fix CE456 - Enter rounding type, rounding increment and unit

SAP Error Message - Details

• Message type: E = Error

• Message class: CE - CAPP messages

• Message number: 456

• Message text: Enter rounding type, rounding increment and unit

What causes this issue?

A rule for rounding before or after the addition of values must always
contain a rounding type, a rounding increment and a unit.

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Maintain the data accordingly.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message CE456 - Enter rounding type, rounding increment and unit ?

  The SAP error message CE456, which states "Enter rounding type, rounding increment and unit," typically occurs in the context of configuring or processing data related to cost centers, internal orders, or other financial transactions where rounding rules are applied.
  Cause:
  This error usually arises when the system expects specific rounding parameters to be defined but finds them missing. The parameters include:
  
  Rounding Type: This defines how the rounding should be applied (e.g., round up, round down, round to nearest).
  Rounding Increment: This specifies the increment to which the values should be rounded (e.g., to the nearest 0.01, 0.05, etc.).
  Unit: This indicates the unit of measure for the rounding (e.g., currency, quantity).
  
  Solution:
  To resolve this error, you need to ensure that the rounding type, rounding increment, and unit are properly defined in the relevant configuration settings. Here are the steps to do this:
  
  
  Access the Configuration:
  
  Go to the SAP Easy Access screen.
  Navigate to the relevant configuration area, typically under Controlling (CO) or Financial Accounting (FI).
  
  
  
  Define Rounding Rules:
  
  Look for the section related to Rounding or Rounding Rules.
  Ensure that you have defined the rounding type, increment, and unit according to your business requirements.
  
  
  
  Check Master Data:
  
  If the error occurs during a transaction, check the master data (e.g., cost center, internal order) to ensure that the rounding parameters are set correctly.
  
  
  
  Test the Configuration:
  
  After making the necessary changes, test the transaction again to see if the error persists.
  
  
  
  Consult Documentation:
  
  If you are unsure about the appropriate settings, refer to SAP documentation or consult with your SAP functional consultant for guidance on the correct rounding configurations.
  
  
  
  Related Information:
  
  Transaction Codes: You may need to use transaction codes like OKKP (for controlling area settings) or KSV5 (for cost center planning) to access the relevant configuration areas.
  SAP Notes: Check for any SAP Notes related to this error message for additional insights or patches that may address specific issues.
  User Authorizations: Ensure that you have the necessary authorizations to make changes to the configuration settings.
  
  By following these steps, you should be able to resolve the CE456 error and ensure that the rounding parameters are correctly set up in your SAP system.