How To Fix /CDBASIS/MSG028 - Customizing parameter &1 is only allowed for operational settings.

/CDBASIS/MSG028 - Overview

• Message type: E = Error

• Message class: /CDBASIS/MSG -

• Message number: 028

• Message text: Customizing parameter &1 is only allowed for operational settings.

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message /CDBASIS/MSG028 - Customizing parameter &1 is only allowed for operational settings. ?

  The SAP error message /CDBASIS/MSG028 indicates that a specific customizing parameter is being used in a context where it is not allowed, specifically outside of operational settings. This error typically arises in the context of SAP's Central Data Management (CDM) or similar modules where certain parameters are restricted to specific configurations.
  
  Cause:
  The error occurs when:
  
  A customizing parameter is being set or modified in a non-operational context (e.g., during a configuration or development phase).
  The parameter in question is intended to be used only in operational settings, which means it should only be configured when the system is in a live or production state.
  
  
  Solution:
  To resolve this error, you can take the following steps:
  
  
  Check the Context: Ensure that you are trying to set or modify the parameter in the correct context. If you are in a development or configuration environment, switch to an operational setting if applicable.
  
  
  Review Customizing Settings: Go to the customizing settings