How To Fix CACSTGT125 - Several units of measure were found for target agreement values

SAP Error Message - Details

• Message type: E = Error

• Message class: CACSTGT - Commissions: Target Agreements

• Message number: 125

• Message text: Several units of measure were found for target agreement values

What causes this issue?

Several units of measure for actual, target and correction values were
found for commission contract &v1& and elementary target type &v2&.
However the defined units of measure are "&v4&".

System Response

Processing was canceled.

How to fix this error?

Correct the units of measure for the target agreement values so that
only one can be used.

Procedure for System Administrators

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message CACSTGT125 - Several units of measure were found for target agreement values ?

  The SAP error message CACSTGT125 indicates that there are multiple units of measure associated with the target agreement values in the system. This typically occurs in the context of target agreements or planning scenarios where the system expects a single unit of measure but finds multiple entries.
  Cause:
  
  Multiple Units of Measure: The primary cause of this error is that the target agreement values are defined with different units of measure (e.g., kilograms, liters, pieces) for the same item or material.
  Data Inconsistency: There may be inconsistencies in the master data or transactional data where the same material is being referenced with different units of measure.
  Configuration Issues: The configuration settings in the SAP system may not be set up correctly to handle the units of measure for the target agreements.
  
  Solution:
  
  Check Target Agreement Values: Review the target agreement values in the system to identify where multiple units of measure are defined. Ensure that each target agreement has a consistent unit of measure.
  Standardize Units of Measure: If multiple units of measure are found, standardize them to a single unit of measure that is appropriate for the target agreement.
  Review Master Data: Check the material master data for the items involved in the target agreement. Ensure that the base unit of measure is correctly defined and that there are no conflicting entries.
  Adjust Configuration: If necessary, review the configuration settings related to target agreements and units of measure in the SAP system. Ensure that the settings allow for the correct handling of units of measure.
  Consult Documentation: Refer to SAP documentation or help resources for specific guidance on handling units of measure in target agreements.
  
  Related Information:
  
  Transaction Codes: You may need to use transaction codes like CJR2 (Change Target Agreement) or CJR1 (Create Target Agreement) to review and modify target agreements.
  Unit of Measure Settings: Familiarize yourself with the unit of measure settings in the material master (transaction code MM02) and how they relate to target agreements.
  SAP Notes: Check for any relevant SAP Notes that may address this specific error or provide additional troubleshooting steps.
  
  If the issue persists after following these steps, it may be beneficial to consult with your SAP support team or a functional consultant who specializes in the relevant module.