How To Fix CACSPSMD047 - Selection table &1 for contract bundle type &2 has no entries

SAP Error Message - Details

• Message type: E = Error

• Message class: CACSPSMD - ICM: Partnerships, Master Data

• Message number: 047

• Message text: Selection table &1 for contract bundle type &2 has no entries

What causes this issue?

An error has occurred while attempting to access the selection table
assigned to the <DS:GLOS.41234AB4880DD511BCBE0800060D9C68>contract
bundle type</>. The table is empty.

System Response

The distribution ratios for this partnership cannot be displayed or
edited.

How to fix this error?

Check the settings of the corresponding contract bundle type and
partnership type in Customizing of <ZK>Incentive and Commission
Management</> under <ZK>Basic and Master Data</> -> <ZK>Contract Bundle
</> and <ZK>Partnerships</>.

Procedure for System Administrators

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message CACSPSMD047 - Selection table &1 for contract bundle type &2 has no entries ?

  The SAP error message CACSPSMD047 indicates that the selection table for a specific contract bundle type does not have any entries. This typically occurs in the context of contract management or service management within SAP, particularly when dealing with contract bundles.
  Cause:
  
  No Data in the Selection Table: The most straightforward cause is that the selection table specified (denoted by &1) for the contract bundle type (denoted by &2) is empty. This could happen if no contracts have been created for that specific bundle type.
  Incorrect Configuration: There may be a configuration issue where the contract bundle type is not set up correctly, leading to no entries being available.
  Authorization Issues: Sometimes, the user may not have the necessary authorizations to view the entries in the selection table.
  Data Deletion: If data was deleted or not properly migrated, it could lead to an empty selection table.
  
  Solution:
  
  Check Data Entries: Verify if there are any entries in the selection table for the specified contract bundle type. You can do this by navigating to the relevant transaction or table in SAP.
  Create Entries: If there are no entries, you may need to create new contract bundles or ensure that the relevant data is populated in the selection table.
  Review Configuration: Check the configuration settings for the contract bundle type to ensure it is set up correctly. This may involve reviewing customizing settings in the SAP system.
  Authorization Check: Ensure that the user has the necessary authorizations to access the data. You may need to consult with your SAP security team to verify this.
  Consult Documentation: Refer to SAP documentation or help resources for specific guidance on the contract bundle type and selection table in question.
  
  Related Information:
  
  Transaction Codes: Depending on your SAP version, you may use transaction codes like SE11 (Data Dictionary) to check the structure of the selection table or SE16 (Data Browser) to view the contents of the table.
  SAP Notes: Check for any relevant SAP Notes that might address this specific error or provide additional troubleshooting steps.
  Support: If the issue persists after checking the above points, consider reaching out to SAP support or your internal SAP support team for further assistance.
  
  By following these steps, you should be able to identify the cause of the error and implement a solution.