How To Fix CACSIB484 - New processing target &1 not allowed

CACSIB484 - Overview

• Message type: E = Error

• Message class: CACSIB - Commissions: Interface and Pending Case Processing

• Message number: 484

• Message text: New processing target &1 not allowed

What causes this issue?

Before processing, your commission case had the processing status &V3&
in state &V2&. The new processing target &V1& is therefore not
permitted.

System Response

The commission case is set to pending.

How to fix this error?

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Procedure for System Administrators

A non-permitted change was made to the processing target for event (BTE
"&V4&").
You can find the permitted processing targets from a commission case
status in the TCACS_VALTARG1 table (V_TCACS_VALTARG1 view).

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message CACSIB484 - New processing target &1 not allowed ?

  The SAP error message CACSIB484, which states "New processing target &1 not allowed," typically occurs in the context of SAP's Incentive and Commission Management (ICM) module. This error indicates that there is an issue with the processing target that you are trying to set or use in your transaction or process.
  
  Cause:
  
  Invalid Processing Target: The processing target you are trying to use may not be defined or allowed in the current context. This could be due to configuration settings or restrictions in the system.
  
  Configuration Issues: There may be configuration settings in the ICM that restrict the use of certain processing targets based on specific criteria (e.g., status, type of transaction).
  Data Integrity Issues: The data associated with the processing target may be incomplete or incorrect, leading to the error.
  
  
  Solution:
  
  Check Configuration: Review the configuration settings for the processing targets in the ICM module. Ensure that the processing target you are trying to use