How To Fix CACSELTENH010 - ELT document &1: &2/&3 reversed in simulation mode

SAP Error Message - Details

• Message type: E = Error

• Message class: CACSELTENH - ELT Enhancements

• Message number: 010

• Message text: ELT document &1: &2/&3 reversed in simulation mode

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message CACSELTENH010 - ELT document &1: &2/&3 reversed in simulation mode ?

  The SAP error message CACSELTENH010 typically indicates that there is an issue with the processing of an ELT (Electronic Logistics Transport) document in simulation mode. This error message suggests that the document has been reversed, which can occur for various reasons during the simulation of logistics processes.
  Cause:
  
  Reversal of Document: The error indicates that the ELT document has been reversed in simulation mode. This could happen if there was an attempt to simulate a process that is not valid or if the document was previously reversed in the system.
  Incorrect Configuration: There may be configuration issues in the system that are causing the simulation to behave unexpectedly.
  Data Inconsistencies: There could be inconsistencies in the data related to the ELT document, such as missing or incorrect entries.
  User Actions: A user may have inadvertently triggered a reversal of the document during the simulation.
  
  Solution:
  
  Check Document Status: Verify the status of the ELT document in question. Ensure that it is in a state that allows for simulation and has not been reversed or marked for reversal.
  Review Simulation Parameters: Check the parameters and settings used for the simulation. Ensure that they are correctly configured and that the document is valid for the actions being simulated.
  Consult Logs: Look at the application logs or system logs for more detailed information about the error. This may provide insights into what caused the reversal.
  Data Validation: Validate the data associated with the ELT document to ensure there are no inconsistencies or missing information.
  Recreate Simulation: If necessary, try to recreate the simulation from scratch to see if the issue persists. This can help identify if the problem is with the specific document or the simulation process itself.
  Contact Support: If the issue cannot be resolved through the above steps, consider reaching out to SAP support for further assistance. They may have additional tools or insights to help diagnose the problem.
  
  Related Information:
  
  SAP Notes: Check for any relevant SAP Notes that may address this specific error message or provide guidance on similar issues.
  Documentation: Review SAP documentation related to ELT processing and simulation modes to ensure compliance with best practices.
  Community Forums: Engage with SAP community forums or user groups where similar issues may have been discussed, and solutions shared.
  
  By following these steps, you should be able to identify the cause of the error and implement a solution to resolve it.