How To Fix CACSDET053 - Cannot use determination combination of analysis mode

SAP Error Message - Details

• Message type: E = Error

• Message class: CACSDET - Messages for Determination

• Message number: 053

• Message text: Cannot use determination combination of analysis mode

What causes this issue?

The system did not find a determination configuration for the analysis
mode in table <ZK>process configuration</> (TCACS_DETCFG). Instead the
configuration of the process mode was found, which is being used for the
determination process.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

If you wish to use different configurations for the analysis mode and
the process mode, you should enter the corresponding entries in the
process configuration table TCACS_DETCFG.

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message CACSDET053 - Cannot use determination combination of analysis mode ?

  The SAP error message CACSDET053 ("Cannot use determination combination of analysis mode") typically occurs in the context of SAP Convergent Charging (SAP CC) when there is an issue with the configuration of the determination rules or analysis modes used in the charging process.
  Cause:
  
  Incorrect Configuration: The error often arises when the determination combination set in the analysis mode does not match the available configurations in the system. This could be due to missing or incorrectly defined rules.
  Incompatible Analysis Modes: The analysis mode being used may not be compatible with the determination rules defined in the system.
  Data Inconsistencies: There may be inconsistencies in the data or settings that prevent the system from correctly applying the determination rules.
  
  Solution:
  
  Check Configuration: Review the configuration of the determination rules and ensure that they are correctly set up. Make sure that the analysis mode you are trying to use is properly defined and that all necessary rules are in place.
  Validate Analysis Modes: Ensure that the analysis mode you are using is compatible with the determination rules. You may need to adjust the analysis mode or the rules to ensure they align.
  Review Logs: Check the logs for more detailed error messages or warnings that could provide additional context about what is causing the issue.
  Test with Different Combinations: If possible, test different combinations of determination rules and analysis modes to identify which specific combination is causing the error.
  Consult Documentation: Refer to the SAP documentation for Convergent Charging to understand the expected configurations and any prerequisites for the determination rules and analysis modes.
  Seek Support: If the issue persists, consider reaching out to SAP support or consulting with an SAP expert who specializes in Convergent Charging for further assistance.
  
  Related Information:
  
  SAP Notes: Check for any relevant SAP Notes that may address this specific error or provide guidance on configuration best practices.
  Community Forums: Engage with SAP community forums or user groups where similar issues may have been discussed, and solutions shared.
  Training and Documentation: Ensure that you have access to the latest training materials and documentation related to SAP Convergent Charging, as this can provide insights into proper configuration and troubleshooting steps.
  
  By following these steps, you should be able to identify the root cause of the error and implement a solution to resolve it.